What does dmesg say? And you said having....
alias eth0 hp-plus
alias eth1 3c509
...in /etc/conf.modules fails to brings up both interfaces nicely?
wendy
[EMAIL PROTECTED] on 01/25/2000 09:19:12 AM
Please respond to [EMAIL PROTECTED]
Sent by: [EMAIL PROTECTED]
To: techtalk <[EMAIL PROTECTED]>
cc: (Wendy Winslow/HQ/3Com)
Subject: [techtalk] RH6.0 2eth cards
Hey All,
I'm having a problem with RH6.0 and was wondering if
anyone could help me. I have 2 ethernet cards, the
first eth0 uses module (3c509), the second eth1 uses
module (hp-plus) which has a dependence on (8390). My
conf.modules is set up like so:
alias eth0 3c509
alias eth1 hp-plus
Upon execution of runlvl 3 it skips pass the 3c509 and
loads the hp-plus as eth0. Then during eth1
initialization it fails. Typing lsmod show that the hp
card has loaded successfully but not the 3com. If I do
a lsmod 3c509 it loads immediately as eth1. I have
tried swapping the entries around in /etc/conf.modules
to no luck.
Also, to compound this some times when switching
runlvl's from 3 to 1 to 3 the cards will occasionally
load up properly. I can't figure out what the heck is
going on here.
Sorry this message is so lengthy I wanted to be as
detailed as possible. Thanks everyone.
Kind Regards,
Harry Hoffman
Product Systems Specialist
Restaurants Unlimited Inc.
(206) 634-3082 x. 270
************
[EMAIL PROTECTED] http://www.linuxchix.org
************
[EMAIL PROTECTED] http://www.linuxchix.org