On Wed, Apr 24, 2019 at 11:16:18PM +0200, Remi Locherer wrote: > On Wed, Apr 24, 2019 at 08:54:08AM +0100, Jason McIntyre wrote: > > On Wed, Apr 24, 2019 at 08:11:42AM +0100, Stuart Henderson wrote: > > > On 2019/04/23 23:53, Remi Locherer wrote: > > > > Hi, > > > > > > > > with below diff the usb serial adapter built into the SRX 300 attaches > > > > to uslcom and can be used. > > > > > > > > uslcom0 at uhub1 port 1 configuration 1 interface 0 "Silicon Labs > > > > Juniper Networks BX Series System Console" rev 1.10/1.01 addr 10 > > > > > > > > OK? > > > > > > > product SILABS KYOCERA_GPS 0x8411 Kyocera GPS > > > > product SILABS IRZ_SG10 0x8418 IRZ SG-10 GSM/GPRS Modem > > > > product SILABS BEI_VCP 0x846e BEI USB Sensor (VCP) > > > > +product SILABS JUNIPER_BX_CONS 0x8470 Juniper BX Series System Console > > > > product SILABS BALLUFF_RFID 0x8477 Balluff RFID reader > > > > product SILABS AC_SERV_IBUS 0x85ea AC-Services IBUS > > > > product SILABS AC_SERV_CIS 0x85eb AC-Services CIS-IBUS > > > > > > The string could be a little shorter, just "Juniper BX Console" > > > is clear enough and saves a few bytes in the kernel. Otherwise OK. > > > Reminder, first commit just usbdevs, then run "make" and commit > > > usbdevs.h/usbdevs_data.h, then the c file. > > > > > > > ...and then update uslcom.4 ;) > > I'm not sure this makes sense. This is not an adapter I buy because I > need serial and only have usb. It's a network device that has this built > in so I can connect to serial with just an usb (mini) cable.r > > And what product should we add to the manual? It works with Juniper SRX 300. > I have no clue if Juniper uses this in other devices. The usb-c connector > from my ICX Switch also attaches to uslcom. Should this also be listet? > > Remi >
hi. no, it's my mistake - sorry! i just presumed it should be listed. jmc
