What you need to do is to be at the standby screen of your N86 for the first
time you use Voice Command on your N86. This only needs to be done once when
first using the Voice Commands on a new phone or after formatting it.
1. Mute Talks. Talks followed by Clear.
2. Press and hold the SoftKey2 button for about 2 seconds and release it.
3. Now press SoftKey1 for YES. This will now enable Voice command on your
phone.
4. You can now unmute Talks with Talks followed by clear.
You will not need to mute Talks again for the voice commands. This is a
issue on the N86 where you will not get the screen about enabling the Voice
Command if Talks isn't muted to start with. I found this out by playing with
the phone a few years back.
Signed: Stephen Giggar
Skype: dr-phone.
Hardware eventually fails, software eventually works.
No amount of bandwidth can fix poor design.
----- Original Message -----
From: "Matthew Chao" <mattc...@verizon.net>
To: <talks@talksusers.com>
Sent: Tuesday, May 10, 2011 6:28 PM
Subject: [Talks] Using Voice Commands on My N86
Hi, Folks! I want to use the voice commands on my N86. However, after
reading the manual and going through the tutorial, i still can't get the
voice commands to work. What am I doing wrong?--Matthew Chao
_______________________________________________
Talks mailing list
Talks@talksusers.com
http://lists.talksusers.com/mailman/listinfo/talks
Hosting of this list provided courtesy of:
eHosting Limited: http://www.ehosting.com/
and
Talknav Inc. http://www.talknav.net/
_______________________________________________
Talks mailing list
Talks@talksusers.com
http://lists.talksusers.com/mailman/listinfo/talks
Hosting of this list provided courtesy of:
eHosting Limited: http://www.ehosting.com/
and
Talknav Inc. http://www.talknav.net/
