Which driver have you used? RawText? zText? That might influence a buffer size.
On Fri, May 2, 2025, 9:07 AM David Haslam <dfh...@protonmail.com> wrote: > While experimenting with the *KhmerNT* module eXperimental improvement, I > encountered a new issue after creating modules using *imp2vs* > > Earlier today, I had the "bright idea" of replacing all the ZWSP between > Khmer words with the following OSIS element. NB. The marker attribute > contains a ZWSP character > > <milestone marker="" type="x-lexical-word-divider" subtype="x-ZWSP"/> > > Nothing wrong with that, you might assume, like I did. > It's perfectly valid OSIS according to our schema and wiki. > It's also much more explicit than simply leaving the ZWSP characters > invisible to the naked eye. > > Only a few smaller books in the NT ever got compiled! > Or if they did compile OK, afterwards SWORD cannot read parts of them. > > So, I thinks to myself, "let's make it a bit smaller", and I then tried > again with this abbreviated attribute value. > > <milestone marker="" type="x-LWD" subtype="x-ZWSP"/> > > A few more NT books were compiled this time, but the largest one visible > was *Hebrews*. > The apparently missing books just show as empty verses in *Xiphos* and > with *emptyvss*. > > I have attached the log file generated during the second attempt at module > build. > NB. The *error.log* was empty, which now rather makes me think it's a > SWORD output issue. > > Using *diatheke* and *mod2imp* after the module was built, one or either > of these gave this repeated message: > > *ERROR: not enough room in the out buffer during decompression.* > > Evidently "Too many milestones can cook your buffer?" > > I'd be happy to supply the IMP file and/or the module for further > investigation. > I think this is a serious issue. I'm surprised that it's never been > encountered hitherto. > > Best regards, > > David > > Sent with Proton Mail <https://pr.tn/ref/SWXT9A5YZ67G> secure email. > _______________________________________________ > sword-devel mailing list: sword-devel@crosswire.org > http://crosswire.org/mailman/listinfo/sword-devel > Instructions to unsubscribe/change your settings at above page >
_______________________________________________ sword-devel mailing list: sword-devel@crosswire.org http://crosswire.org/mailman/listinfo/sword-devel Instructions to unsubscribe/change your settings at above page