It should work fine on CPython 2.6+ and 3.0+ (or might require 3.1 or
so--I don't think I tested very low versions of Python3).
I have tested on a few different platforms with various versions of
Python and haven't seen any problems on that front. IIRC, one or two of
the non-CPython Pythons do work but at least one does not, so YMMV if
you're into non-CPython Pythons.
--Chris
On 05/07/2013 10:53 AM, Greg Hellings wrote:
On Tue, May 7, 2013 at 12:46 PM, David Haslam <dfh...@googlemail.com
<mailto:dfh...@googlemail.com>> wrote:
Hi Peter,
Which version of Python did you use it with ?
Has anyone been successful with Python 3.3.x ?
Chris designed it for CPython 2.7+ (but support CPython 3 and other
interpreters if possible).
I used it with CPython 2.7. I believe Chris designed it so it could be
run on Python 3 eventually, but I don't think it is fully compatible
yet. Since 2.7 is still the default on most Unix/Linux systems it makes
sense to err on the 2.x side for now.
--Greg
cf. python.org <http://python.org> states:
If you don't know which version to use, try Python 3.3. Some existing
third-party software is not yet compatible with Python 3;
if you need to use such software, you can download Python 2.7.x instead.
David
--
View this message in context:
http://sword-dev.350566.n4.nabble.com/usfm2osis-py-tp4652232p4652239.html
Sent from the SWORD Dev mailing list archive at Nabble.com.
_______________________________________________
sword-devel mailing list: sword-devel@crosswire.org
<mailto:sword-devel@crosswire.org>
http://www.crosswire.org/mailman/listinfo/sword-devel
Instructions to unsubscribe/change your settings at above page
_______________________________________________
sword-devel mailing list: sword-devel@crosswire.org
http://www.crosswire.org/mailman/listinfo/sword-devel
Instructions to unsubscribe/change your settings at above page
_______________________________________________
sword-devel mailing list: sword-devel@crosswire.org
http://www.crosswire.org/mailman/listinfo/sword-devel
Instructions to unsubscribe/change your settings at above page
