Hi Luke
I have the same problem with Cisco Series 800 Router.
And so far I've solved it by adding a few lines to the startup-config.
For every VLAN:
vlan xxx
state active
Regards
Florian
Am 25.07.2013 16:07, schrieb Lukas Eisenberger:
Hi Erich
Thank you for your answer. I also saw this in the documentation. But
the switch behaves differently.
If I have a switch with already configured vlans with vtp mode
transparent (with the same infos in vlan.dat ) then only the higher
numbered vlans are going to be applied from the startup config. The
lower numbered vlans are copied from vlan.dat to the configuration.
Regards
Luke
2013/7/24 Erich Hohermuth <[email protected] <mailto:[email protected]>>
Hi
Regarding to the cisco docu (1) it depends on the vtp mode and the
config of vlan.dat.
If both the VLAN database and the configuration file show the VTP mode
as transparent and the VTP domain names match, the VLAN database is
ignored. The VTP and VLAN configurations in the startup configuration
file are used. The VLAN database revision number remains unchanged in
the VLAN database.
If there is no vlan.dat file, or if the vlan.dat cannot be read, the
switch boots with the default vlan characteristics. You can use the
archiv commands to safe and restore the vlan.dat file.
Regards
Erich
[1]
http://www.cisco.com/en/US/products/hw/switches/ps5213/products_tech_note09186a0080a49dbf.shtml
Am Wed Jul 24 14:35:15 2013 schrieb Lukas Eisenberger:
> So during the miration I want to do something like this:
>
> copy tftp://10.6.100.3/config.txt <http://10.6.100.3/config.txt>
<http://10.6.100.3/config.txt>
> startup-config
> and do a reload
> or
> configure replace tftp://10.6.100.3/config.txt
<http://10.6.100.3/config.txt>
> <http://10.6.100.3/config.txt>
>
> I tested my miration path in the lab and I figured out that low
> numbering vlans in the range of 2-1001 are for some strange
reason not
> applied to the config. I tried also deleting vlan.dat and change to
> vtp of or transparent/server/client and diffrent vtp versions before
> applying the config without success.
>
> Does somebody have a clou about the strange behaviour?
_______________________________________________
swinog mailing list
[email protected]
http://lists.swinog.ch/cgi-bin/mailman/listinfo/swinog
_______________________________________________
swinog mailing list
[email protected]
http://lists.swinog.ch/cgi-bin/mailman/listinfo/swinog
