Respected Sir, Thank you so much for your response. Regards, Mayank
On Fri, 2 Jun 2023 at 14:45, [email protected] < [email protected]> wrote: > You have to define a detector for each set of vehicle types you want to > track: Set the vtypes attribute of the respective detector to the vehicle > types you want detect there. See docs > <https://sumo.dlr.de/docs/Simulation/Output/Induction_Loops_Detectors_%28E1%29.html#instantiating_within_the_simulation> > . > > > > Best regards > > Mirko > > > > > > > > > > -----Original-Nachricht----- > > Betreff: Re: [sumo-user] Specific Value for depart speed: > > Datum: 2023-06-02T09:00:32+0200 > > Von: "Mayank Singh" <[email protected]> > > An: "Sumo project User discussions" <[email protected]> > > > > > > > Respected Sir, > Currently, I am using an E1 loop detector, and I am able to get flow, > speed, and occupancy information. > In the simulated traffic, there are two types: cars and trucks. > How can we get the above parameters for each vehicle type separately? > Please guide us. > > > Regards, > Mayank > > > > On Wed, 31 May 2023 at 20:41, Mayank Singh <[email protected]> > wrote: > >> Thank you Sir for your response. >> Actually, we misspelled it. >> Now, it is resolved. >> >> Regards, >> Mayank >> >> On Wed, 31 May, 2023, 8:05 pm Jakob Erdmann, <[email protected]> >> wrote: >> >>> This might happen if you misspell the attribute or put it into the wrong >>> element. To help with this problem, you can enable input validation by >>> defining the root element of your route file as: >>> <routes xmlns:xsi="http://www.w3.org/2001/XMLSchema-instance"; >>> xsi:noNamespaceSchemaLocation="http://sumo.dlr.de/xsd/routes_file.xsd";> >>> The correct definition is departSpeed="20" placed inside the >>> vehicle/trip/flow element >>> >>> Am Mi., 31. Mai 2023 um 15:26 Uhr schrieb Mayank Singh < >>> [email protected]>: >>> >>>> Respected Sir, >>>> >>>> I want to insert vehicles with some specific "depart speed", e.g., 20 >>>> m/s, and different departure speeds for different vehicles. >>>> For that, I have initialized the "depart-speed" attribute of every >>>> vehicle. >>>> >>>> But the FCD output shows that all the vehicles start with an initial >>>> speed of 0.0 m/s and then accelerate based on the acceleration value. >>>> >>>> Kindly help me to get the non-zero "depart speed" of vehicles. >>>> >>>> >>>> Regards, >>>> Mayank >>>> _______________________________________________ >>>> sumo-user mailing list >>>> [email protected] >>>> To unsubscribe from this list, visit >>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>> >>> _______________________________________________ >>> sumo-user mailing list >>> [email protected] >>> To unsubscribe from this list, visit >>> https://www.eclipse.org/mailman/listinfo/sumo-user >> >> > > _______________________________________________ > sumo-user mailing list > [email protected] > To unsubscribe from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list [email protected] To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
