Hello Jakob, Bits 3 and 2 make sense to me now, along with the example. Thank you. Just 2 more questions on bits 9 and 8:
*1. "adapt speed to fulfill request" describes that traci changes are treated with "urgency" and thus on the same level as strategic changes*. So when these bits are set on the lane change mode for the *ego* agent, then the *other* vehicles will assist the ego vehicle to achieve the necessary gaps? Or do these bits have to be set for the lane change mode of the other vehicles too? 2. The nature of the speed adaptation is always only longitudinal and will consist of these other vehicles either speeding up or slowing down to create an opening for the ego vehicle to lane change into that opening? Please advise. Sincerely, Hriday On Wed, 4 May 2022 at 15:54, Jakob Erdmann <[email protected]> wrote: > - bits 9 and 8 are only applied to user-requested traci changes. the > statement "adapt speed to fulfill request" describes that traci changes are > treated with "urgency" and thus on the same level as strategic changes. > When this is set, other vehicles will assist the ego vehicle to achieve the > necessary gaps. > - bits 3 and 2 only control lateral cooperative movement but this applies > to things that the vehicle (it's lanechangemodel) would do when left alone. > The bits have no impact on traci.changeLane and similar commands. > > > in what situation does a vehicle need to "cooperatively" change lane to > "allow" another vehicle to change lane? Since the vehicle could just > increase its speed to create a gap? > consider an on ramp to a two-lane motorway A vehicle on the right lane may > elect to change left for helping a vehicle merge rather than braking to > create a helpful gap. > Also, the merging vehicle cannot ensure a gap by increasing speed since it > is constrain by the length of it's acceleration lane. > > > Am Mi., 4. Mai 2022 um 14:47 Uhr schrieb Hriday Sanghvi via sumo-user < > [email protected]>: > >> Hello, >> >> Setting bits 3 and 2 of the lane change mode controls the cooperative >> changes in a simulation. Setting bits 9 and 8 controls how much the >> speed/brake gaps of others are respected when changing lanes, and >> adaptation of speed to fulfil requests. >> >> As I understand it, the difference between setting bits 3 and 2 vs. >> setting bits 9 and 8 is that bits 3 and 2 control only the lateral action >> of changing lanes, while setting bits 9 and 8 controls the longitudinal >> action of speeding up or slowing down? >> >> In that case, in what situation does a vehicle need to "cooperatively" >> change lane to "allow" another vehicle to change lane? Since the vehicle >> could just increase its speed to create a gap? >> >> Thank you. >> >> Sincerely, >> Hriday >> _______________________________________________ >> sumo-user mailing list >> [email protected] >> To unsubscribe from this list, visit >> https://www.eclipse.org/mailman/listinfo/sumo-user >> > _______________________________________________ > sumo-user mailing list > [email protected] > To unsubscribe from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list [email protected] To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
