Hello,
I installed STAF exactly as described in the hands-on demo, I always get
this warning whenever I run any command for any service, even when I'm just
starting STAF for the first time (stafproc):
Could not open file C:\STAF\codepage/ibm-720.bin
WARNING: Defaulting to LATIN_1
After the warning, response messages are displayed normally on the following
lines, but how can I get rid of this warning?
Thanks a lot
--
Ahmed Mostafa
0123919750
[EMAIL PROTECTED]
Software Developer
IBM Software Group
IBM Egypt, Cairo Technology Development Center
Cairo, Alexandria Desert Road, KM 22, Giza, Egypt
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
staf-users mailing list
staf-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/staf-users
