You'll need to share your Kamailio config and some details of your network setup (specifically if NAT is involved).
Phil -----Original Message----- From: sr-users [mailto:sr-users-boun...@lists.sip-router.org] On Behalf Of Baris Sekerciler Sent: 29 January 2016 08:35 To: sr-users@lists.sip-router.org Subject: [SR-Users] Kamailio v4.3 and Freeswitch Stable Latest Hello everyone. I'm a student and I'm working on project which about SIP communication and PBXs with IP phones. So, my first test results were OK with JITSI. But I think I need Freeswitch for working with IP phones. In a word, I need configure an integration Kamailio and Freeswitch. First, I setup Debian 8.3 Jessie and installed Kamailio on this my local server, after that I installed another Debian 8.3 Jessie (from same image) as my second server and it was going to run Freeswitch on itself. Then I tried to send my communication requests to my Freeswitch server. I made some tests, my Jitsi accounts which are set in Kamailio server were done. I've read Kamailio 3.2 and Freeswitch integration from the Kamailio wiki and I applied exactly the same thing but I did not work. When I tried to reach another IP phone from my IP phone (I registered them) phone always say "NOT FOUND". I'm sure I did my configuration properly. So, how can I figure it out these things? How can I understand, does Kamailio routes to Freeswitch to my phones? Best regards. Thanks. _______________________________________________ SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list sr-users@lists.sip-router.org http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users _______________________________________________ SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list sr-users@lists.sip-router.org http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users
