That works great for Asterisk but I'm working with a PortaOne PortaSIP commercial soft switch.
Any suggestions? From: SamyGo <govoi...@gmail.com> Reply-To: "SIP Router - Kamailio (OpenSER) and SIP Express Router (SER) - Users Mailing List" <sr-users@lists.sip-router.org> Date: Wed, 21 Mar 2012 09:23:47 +0500 To: <mico...@gmail.com>, "SIP Router - Kamailio (OpenSER) and SIP Express Router (SER) - Users Mailing List" <sr-users@lists.sip-router.org> Subject: Re: [SR-Users] Proxy Registrations offset port Hi Robert, There can't be any simpler start then using the configurations(kamailio.cfg file) mentioned in this blog-post by Daniel. http://kb.asipto.com/asterisk:realtime:kamailio-3.1.x-asterisk-1.6.2-astdb You can see a route[REGFWD] and in that route you can relay the REGISTRATIONS to your desired SIP-Server!! This is by far the easiest and simplest start I've found without any headache of going deeper into the SIP packets and techniques. See this is the concerned route.Make sure you do DB tables and Variables adjustments accordingly. Regards, Sammy. NOTE: Thanks Sir Daniel for these wonderful and very helpful blogposts. On Wed, Mar 21, 2012 at 3:41 AM, Daniel-Constantin Mierla <mico...@gmail.com> wrote: > > Hello, > > > On 3/20/12 10:36 PM, Robert wrote: >> >> I've spent a significant amount of time now jacking with configurations >> >> >> >> >> Maybe I should re-state what I'm trying to do >> >> >> >> >> I'm trying to establish an SBC / UpperRegistration SBC >> >> >> >> >> The goal is to listen on a port other than 5060 and relay the registration >> to the actual proxy. >> >> >> >> >> I.e. IP Phone ---> Kamailio (port 8080) ----> Sip proxy (port 5060) >> >> >> >> >> I've tried all combinations of rewritehostport / t_replicate etc >> > perhaps t_relay_to(...) is enough, depending on what the r-uri address > contain (should be registrar server address, if K on port 8080 is used as > outbound proxy). > > You have to use path module and the sip proxy on 5060 has to understand the > path headers (it is not clear that proxy on 5060 is Kamailio, if it is, then > it support path). > > > >> >> >> >> >> The best I get is an attempt to register followed by an unauthorized with >> request for digest auth.. >> >> >> >> >> I don't want to store any credentials in Kamailio I just want to act as an >> offset port for users who cannot reach 5060 >> > > Forwarding registrations is fine, no need to authenticate them on K port > 8080. Perhaps providing the relevant part of your config along with a ngrep > SIP trace on K port 8080 will help to give you the right directions to get it > work. > > Cheers, > Daniel > > > >> >> >> >> >> OpenSBC was working for this however the registrations were timing out and >> not renewing >> >> >> >> >> >> >> >> From: Reda Aouad <reda.ao...@gmail.com> >> Reply-To: "SIP Router - Kamailio (OpenSER) and SIP Express Router (SER) - >> Users Mailing List" <sr-users@lists.sip-router.org> >> Date: Fri, 9 Mar 2012 17:16:14 +0100 >> To: "SIP Router - Kamailio (OpenSER) and SIP Express Router (SER) -Users >> Mailing List" <sr-users@lists.sip-router.org> >> Subject: Re: [SR-Users] Proxy Registrations offset port >> >> >> >> >> >> >> >> No wonder your signallin is not reaching the final client. >> >> >> >> >> I didnt't suggest to throw OpenSips. NAT handling is delicate woth proxies. >> >> >> >> >> Start by looking at some wireshark dump to see what's wrong. >> >> >> >> >> Reda >> >> >> On 9 mars 2012, at 16:57, Robert <rob...@inteli-core.com> wrote: >> >> >> >>> >>> >>> Two different tests I completed: >>> >>> >>> >>> >>> Test #1 it showed the opensips server >>> >>> Test #2 it showed the client's public ip address >>> >>> >>> >>> >>> The issue is not as much RTP but I'm not getting SIP signaling back to the >>> client.. Which leads me to believe the NAT problem. I'm not even getting >>> ringing >>> >>> >>> >>> >>> Maybe I should go ahead and install Kamailio and throw out the OpenSIPs >>> stuff >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> >>> From: Reda Aouad <reda.ao...@gmail.com> >>> Reply-To: "SIP Router - Kamailio (OpenSER) and SIP Express Router (SER) - >>> Users Mailing List" <sr-users@lists.sip-router.org> >>> Date: Fri, 9 Mar 2012 16:41:57 +0100 >>> To: "SIP Router - Kamailio (OpenSER) and SIP Express Router (SER) -Users >>> Mailing List" <sr-users@lists.sip-router.org> >>> Subject: Re: [SR-Users] Proxy Registrations offset port >>> >>> >>> >>> >>> >>> >>> >>> Kamailio's default conf is really a good place to start, you just have to >>> disable the authentication, by commenting the corresponding route. >>> >>> You can start by looking at a wireshark/tcpdump dump on your PortaOne >>> server to know where the rtp stream is going, and then troubleshoot >>> accordingly.. >>> >>> >>> >>> >>> On your PortaOne server, what is the location of registered users? Is it >>> their IP@, or that of OpenSips server? >>> >>> >>> >>> Reda >>> >>> >>> On 9 mars 2012, at 16:28, Robert <rob...@inteli-core.com> wrote: >>> >>> >>> >>>> >>>> >>>> Thank you so much for answering.. The folks at the other place don't want >>>> to help. >>>> >>>> >>>> >>>> >>>> We have a PortaOne SIP platform It does everything It's listening on port >>>> 5060 public ip.. >>>> >>>> >>>> >>>> >>>> We want to deploy Kamailio or some derivative of SER to listen on PUBLIC >>>> port other than 5060 for our customers who cannot reach 5060. >>>> >>>> >>>> >>>> >>>> Using a very simple rewritehostport statement I was successful in getting >>>> the registration to pass through. I.e. Registered my Aastra and X-Lite to >>>> port 8080 and saw registration in PortaOne. >>>> >>>> >>>> >>>> >>>> I do not want K/SER to do actual auth / registration I.e. I do not care >>>> who tries to use it I want final registration to be PortaOne That's why >>>> I think the simple rewritehostport worked well. OpenSIPS was not doing any >>>> auth just simply passing it on. >>>> >>>> >>>> >>>> >>>> Our PortaOne was handling RTP Proxy so during an outbound call I was >>>> getting 2 way audio no problem. >>>> >>>> However when an inbound call would come in from PortaOne it was being >>>> delivered to OpenSIPS and looks like Opensips was reporting 401 >>>> Unauthorized. >>>> >>>> >>>> >>>> >>>> The Aastra / X-Lite are NAT It's possible that either I need to look at >>>> nathlper closer or that I misconfigured something somewhere. >>>> >>>> >>>> >>>> >>>> I guess I'm not fluent enough in the configs and options to get a good >>>> config. >>>> >>>> >>>> >>>> >>>> >>>> >>>> >>>> From: Reda Aouad <reda.ao...@gmail.com> >>>> Reply-To: "SIP Router - Kamailio (OpenSER) and SIP Express Router (SER) - >>>> Users Mailing List" <sr-users@lists.sip-router.org> >>>> Date: Fri, 9 Mar 2012 15:45:14 +0100 >>>> To: "SIP Router - Kamailio (OpenSER) and SIP Express Router (SER) - Users >>>> Mailing List" <sr-users@lists.sip-router.org> >>>> Subject: Re: [SR-Users] Proxy Registrations offset port >>>> >>>> >>>> >>>> >>>> >>>> Hi Robert, >>>> >>>> >>>> >>>> I had the same feeling about O***sips community..... >>>> >>>> >>>> >>>> >>>> I have a similar setup. A proxy that listens on port other than 5060, >>>> forwarding to other servers on 5060. >>>> >>>> If you can better define better your problem with your setup, maybe we can >>>> help you better. >>>> >>>> >>>> >>>> >>>> Is your server listening only on one port 8080? Is your server behind NAT >>>> or does it have a public IP @ on the interface it's listening on? What is >>>> the exact problem with inbound calls? Are you doing record-route? Do you >>>> forward only registrations, or are your handling invites as well? What >>>> server listens on port 5060? Another Kamailio server? Does it handle >>>> clients behind NAT? >>>> >>>> >>>> >>>> >>>> You should know that Kamailio is a SIP server, not a PBX/sofswitch/SBC as >>>> Asterisk or Freeswitch. >>>> >>>> If you define better your problem, and send me your config file (by private >>>> email if you like), I may look at it. >>>> >>>> >>>> >>>> >>>> >>>> >>>> Reda >>>> >>>> >>>> >>>> >>>> >>>> On Fri, Mar 9, 2012 at 15:32, Robert <rob...@inteli-core.com> wrote: >>>> >>>>> >>>>> >>>>> I've been playing with OpenSIPS and am willing to change over if it means >>>>> I'll get a more informed answer from this community.. >>>>> >>>>> >>>>> >>>>> >>>>> I need to set up a proxy forwarding server that can listen on a port other >>>>> than 5060 I.e. 8080 and forward the registration requests to another >>>>> Voip platform we have that is running on 5060. >>>>> >>>>> >>>>> >>>>> >>>>> I've been able to this under OpenSIPS but I'm having issues with inbound >>>>> calls. It could be a NAT issue. >>>>> >>>>> >>>>> >>>>> >>>>> Basically listen on 8080 forward any and all registrations to x:5060 >>>>> which I've done using rewritehostport >>>>> >>>>> >>>>> >>>>> >>>>> Anyone have any good example configs for this? I'm a n00b at this OpenSER >>>>> stuff but have been around asterisk / freeswitch / portaone for a while. >>>>> >>>>> >>>>> >>>>> >>>>> Thanks in advance >>>>> >>>>> >>>>> _______________________________________________ >>>>> SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list >>>>> sr-users@lists.sip-router.org >>>>> http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users >>>>> >>>>> >>>> >>>> >>>> >>>> >>>> _______________________________________________ SIP Express Router (SER) >>>> and Kamailio (OpenSER) - sr-users mailing list >>>> sr-us...@lists.sip-router.orghttp://lists.sip-router.org/cgi-bin/mailman/li >>>> stinfo/sr-users >>>> >>> >>>> >>>> _______________________________________________ >>>> SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list >>>> sr-users@lists.sip-router.org >>>> http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users >>>> >>>> >>> >>> >>> _______________________________________________ SIP Express Router (SER) >>> and Kamailio (OpenSER) - sr-users mailing list >>> sr-us...@lists.sip-router.orghttp://lists.sip-router.org/cgi-bin/mailman/lis >>> tinfo/sr-users >>> >> >>> >>> _______________________________________________ >>> SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list >>> sr-users@lists.sip-router.org >>> http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users >>> >>> >> >> >> _______________________________________________ SIP Express Router (SER) and >> Kamailio (OpenSER) - sr-users mailing list sr-users@lists.sip-router.org >> http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users >> >> >> _______________________________________________ >> SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list >> sr-us...@lists.sip-router.orghttp://lists.sip-router.org/cgi-bin/mailman/list >> info/sr-users >> > > > -- > Daniel-Constantin Mierla > Kamailio Advanced Training, April 23-26, 2012, Berlin, Germany > http://www.asipto.com/index.php/kamailio-advanced-training/ > > > _______________________________________________ > SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list > sr-users@lists.sip-router.org > http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users > _______________________________________________ SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list sr-users@lists.sip-router.org http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users
_______________________________________________ SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list sr-users@lists.sip-router.org http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users
