In the later versions, you could use the following parameter:

3.23. ds_probing_mode (int)

Controls what gateways are tested to see if they are reachable. If set
to 0, only the gateways with state PROBING are tested, if set to 1,
all gateways are tested. If set to 1 and the response is 408
(timeout), an active gateway is set to PROBING state.

Default value is “0”.

Example 1.24. Set the “ds_probing_mode” parameter

 ...
 modparam("dispatcher", "ds_probing_mode", 1)
 ...

In this case, the Dispatcher module would send a OPTIONS-request to
all the gateways and if it replies with a "200 OK", enable them
again....

Carsten

2011/6/29 vaad.f...@gmail.com <vaad.f...@gmail.com>:
>  Hi all,
>
>
> Is it possible to autochange gateway's state from pending to active after gw
> get up ?
>
> http://www.kamailio.org/docs/modules/1.4.x/dispatcher.html says only about
> ping caused autochange state from active to  pending, but nothing about
> change gw's state back.
>
> --
> Vadim F.
>
>
> _______________________________________________
> SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list
> sr-users@lists.sip-router.org
> http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users
>



-- 
Carsten Bock
http://www.ng-voice.com
mailto:cars...@ng-voice.com

Schomburgstr. 80
22767 Hamburg
Germany

Mobile +49 179 2021244
Office +49 40 34927219
Fax +49 40 34927220

_______________________________________________
SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list
sr-users@lists.sip-router.org
http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users

Reply via email to