Hello, On 7/28/10 7:13 PM, JinKevin wrote: > Hi Daniel, > > Here is the debug message related to nethelper in the kamailio log: > The proxy is circling btw enabled and disabled, what could be the cause?
can you run rtpproxy in debug mode and see if it prints some error? I cannot think to something else than network communication problems. Cheers, Daniel > > 4(15247) DEBUG: nathelper [nhelpr_funcs.c:148]: type <application/sdp> > found valid > 4(15247) ERROR: nathelper [nathelper.c:3144]: no available proxies > 1(15244) DEBUG: nathelper [nhelpr_funcs.c:148]: type <application/sdp> > found valid > 1(15244) ERROR: nathelper [nathelper.c:3144]: no available proxies > 2(15245) INFO: nathelper [nathelper.c:2369]: rtp proxy > <udp:127.0.0.1:7722> found, support for it re-enabled > 3(15246) DEBUG: nathelper [nhelpr_funcs.c:148]: type <application/sdp> > found valid > 3(15246) DEBUG: nathelper [nathelper.c:3196]: proxy reply: 46634 > 210.13.x.y > 4(15247) DEBUG: nathelper [nhelpr_funcs.c:148]: type <application/sdp> > found valid > 4(15247) ERROR: nathelper [nathelper.c:2457]: can't send command to a > RTP proxy > 4(15247) ERROR: nathelper [nathelper.c:2492]: proxy > <udp:127.0.0.1:7722> does not respond, disable it > 4(15247) ERROR: nathelper [nathelper.c:3144]: no available proxies > 1(15244) DEBUG: nathelper [nhelpr_funcs.c:148]: type <application/sdp> > found valid > 1(15244) ERROR: nathelper [nathelper.c:3144]: no available proxies > 2(15245) ERROR: nathelper [nathelper.c:2627]: no available proxies > 4(15247) DEBUG: nathelper [nhelpr_funcs.c:148]: type <application/sdp> > found valid > 4(15247) ERROR: nathelper [nathelper.c:3144]: no available proxies > 3(15246) DEBUG: nathelper [nhelpr_funcs.c:148]: type <application/sdp> > found valid > 3(15246) ERROR: nathelper [nathelper.c:3144]: no available proxies > 1(15244) ERROR: nathelper [nathelper.c:2627]: no available proxies > > Thanks, > Kevin > ------------------------------------------------------------------------ > From: kevin....@hotmail.com > To: mico...@gmail.com > CC: sr-users@lists.sip-router.org > Subject: RE: [SR-Users] Kamailio 3.0 cann't access the RTPProxy > Date: Wed, 28 Jul 2010 19:42:27 +0800 > > > Hi, > > Yes, I changed the kamailio config as well, but didn't see any packet > from Kamailio on the port. > And the error message is as following: > > WARNING: tm [uac.c:111]: Warning: uac does not spread across the whole > hash table > ERROR: nathelper [nathelper.c:2457]: can't send command to a RTP proxy > ERROR: nathelper [nathelper.c:2492]: proxy <udp:210.13.x.y:7722> does > not respond, disable it > ERROR: nathelper [nathelper.c:3144]: no available proxies > ERROR: nathelper [nathelper.c:2457]: can't send command to a RTP proxy > ERROR: nathelper [nathelper.c:2492]: proxy <udp:210.13.x.y:7722> does > not respond, disable it > ERROR: nathelper [nathelper.c:3144]: no available proxies > ERROR: nathelper [nathelper.c:2627]: no available proxies > ERROR: nathelper [nathelper.c:2627]: no available proxies > > Thanks, > Kevin > ------------------------------------------------------------------------ > Date: Wed, 28 Jul 2010 10:31:18 +0200 > From: mico...@gmail.com > To: kevin....@hotmail.com > CC: sr-users@lists.sip-router.org > Subject: Re: [SR-Users] Kamailio 3.0 cann't access the RTPProxy > > Hello, > > On 7/27/10 4:21 PM, JinKevin wrote: > > Hi Daniel, > > I use the rtpproxy 1.2.1. And seems loopback interface cann't be > caputred on Solaris. I have tried the rtpproxy on other interface > and tried the caputre, however didn't see anything on port 7722. > > > have you updated kamailio config to send to the other interface as > well? What are now the error messages you get from kamailio? > > You should see the messages sent by kamailio to rtpproxy... > > > One more thing like to mention is that I got some error like below: > > if gcc -DHAVE_CONFIG_H -I. -I. -I. -std=gnu99 -Wall > -Wno-uninitialized -g -O2 -MT rtpp_notify.o -MD -MP -MF > ".deps/rtpp_notify.Tpo" -c -o rtpp_notify.o rtpp_notify.c; \ > then mv -f ".deps/rtpp_notify.Tpo" ".deps/rtpp_notify.Po"; else rm > -f ".deps/rtpp_notify.Tpo"; exit 1; fi > rtpp_notify.c: In function `reconnect_timeout_handler': > rtpp_notify.c:240: error: `AF_LOCAL' undeclared (first use in this > function) > rtpp_notify.c:240: error: (Each undeclared identifier is reported > only once > rtpp_notify.c:240: error: for each function it appears in.) > gmake[1]: *** [rtpp_notify.o] Error 1 > gmake[1]: Leaving directory `/opt/csw/src/rtpproxy' > gmake: *** [all] Error 2 > > > I search on internet and added the following in the beginnng of > the rtpp_notify.c, and the make gets through. Not sure if this > change has any issue. > > #ifndef AF_LOCAL > #define AF_LOCAL AF_UNIX > #endif > > > This is rtpproxy code, perhaps is better to ask on rtpproxy devel list: > http://lists.rtpproxy.org/mailman/listinfo/devel > > Cheers, > Daniel > > > Thanks, > Kevin > > ------------------------------------------------------------------------ > > Date: Tue, 27 Jul 2010 11:53:21 +0200 > From: mico...@gmail.com <mailto:mico...@gmail.com> > To: kevin....@hotmail.com <mailto:kevin....@hotmail.com> > CC: sr-users@lists.sip-router.org > <mailto:sr-users@lists.sip-router.org> > Subject: Re: [SR-Users] Kamailio 3.0 cann't access the RTPProxy > > Hello, > > can you sniff the loopback interface for communication on port > 7722 (i.e., using ngrep/wireshark, etc...)? > > What is the version of rtppproxy do you have? > > Cheers, > Daniel > > > On 7/27/10 3:58 AM, JinKevin wrote: > > Guys, > > Anyone has some feedback on this? > > Thanks, > Kevin > > > ------------------------------------------------------------------------ > > > Hi All, > > > I have the kamailio configed as below on Solaris 10 (Sparc): > > # ----- nathelper ----- > #!ifdef WITH_NAT > modparam("nathelper", "rtpproxy_sock", "udp:127.0.0.1:7722") > modparam("nathelper", "natping_interval", 30) > modparam("nathelper", "ping_nated_only", 1) > modparam("nathelper", "sipping_bflag", 7) > modparam("nathelper", "sipping_from", "sip:pin...@kamailio.org") > modparam("registrar|nathelper", "received_avp", "$avp(i:80)") > modparam("usrloc", "nat_bflag", 6) > #!endif > > and rtpproxy is started as > AppSer01:ipunity@/opt/ipunity$ ps -ef |grep rtp > ipunity 4687 1 0 12:58:20 ? 0:00 /usr/local/bin/rtpproxy -l > 210.xx.xx.xx -s udp:localhost:7722 > > AppSer01:ipunity@/opt/ipunity$ netstat -an |grep 7722 > 127.0.0.1.7722 Idle > 127.0.0.1.41509 127.0.0.1.7722 Connected > 127.0.0.1.41510 127.0.0.1.7722 Connected > 127.0.0.1.41511 127.0.0.1.7722 Connected > 127.0.0.1.41512 127.0.0.1.7722 Connected > 127.0.0.1.41513 127.0.0.1.7722 Connected > 127.0.0.1.41514 127.0.0.1.7722 Connected > 127.0.0.1.41515 127.0.0.1.7722 Connected > 127.0.0.1.41516 127.0.0.1.7722 Connected > 127.0.0.1.41517 127.0.0.1.7722 Connected > 127.0.0.1.41518 127.0.0.1.7722 Connected > 127.0.0.1.41519 127.0.0.1.7722 Connected > > However, kamailio is not able to connect the rtpporxy, > > Jul 24 12:58:59 AppSer01 > /usr/local/kamailio-3.0/sbin/kamailio[22867]: [ID 788202 > local0.error] ERROR: nathelper [nathelper.c:2457]: can't send > command to a RTP proxy > Jul 24 12:58:59 AppSer01 > /usr/local/kamailio-3.0/sbin/kamailio[22867]: [ID 844113 > local0.error] ERROR: nathelper [nathelper.c:2492]: proxy > <udp:127.0.0.1:7722> does not respond, disable it > Jul 24 12:58:59 AppSer01 > /usr/local/kamailio-3.0/sbin/kamailio[22867]: [ID 582370 > local0.error] ERROR: nathelper [nathelper.c:3144]: no > available proxies > Jul 24 12:58:59 AppSer01 > /usr/local/kamailio-3.0/sbin/kamailio[22867]: [ID 788202 > local0.error] ERROR: nathelper [nathelper.c:2457]: can't send > command to a RTP proxy > Jul 24 12:58:59 AppSer01 > /usr/local/kamailio-3.0/sbin/kamailio[22867]: [ID 844113 > local0.error] ERROR: nathelper [nathelper.c:2492]: proxy > <udp:127.0.0.1:7722> does not respond, disable it > Jul 24 12:58:59 AppSer01 > /usr/local/kamailio-3.0/sbin/kamailio[22867]: [ID 582370 > local0.error] ERROR: nathelper [nathelper.c:3144]: no > available proxies > Jul 24 12:59:04 AppSer01 > /usr/local/kamailio-3.0/sbin/kamailio[22870]: [ID 582370 > local0.error] ERROR: nathelper [nathelper.c:2627]: no > available proxies > Jul 24 12:59:04 AppSer01 > /usr/local/kamailio-3.0/sbin/kamailio[22870]: [ID 582370 > local0.error] ERROR: nathelper [nathelper.c:2627]: no > available proxies > > Any helps are appreciated. > > > Thanks, > Kevin > > > ------------------------------------------------------------------------ > 聊天+搜索+邮箱 想要轻松出游,手机MSN帮你搞定! 立刻下载！ > <http://3g.msn.cn/> > > ------------------------------------------------------------------------ > 使用新一代 Windows Live Messenger 轻松交流和共享！ 立刻下载！ > <http://www.windowslive.cn/messenger/> > > > _______________________________________________ > SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing > list > sr-users@lists.sip-router.org <mailto:sr-users@lists.sip-router.org> > http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users > > > > -- > Daniel-Constantin Mierla > http://www.asipto.com/ > > > > ------------------------------------------------------------------------ > 使用新一代 Windows Live Messenger 轻松交流和共享！ 立刻下载！ > <http://www.windowslive.cn/messenger/> > > > _______________________________________________ > SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list > sr-users@lists.sip-router.org <mailto:sr-users@lists.sip-router.org> > http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users > > > > -- > Daniel-Constantin Mierla > http://www.asipto.com/ > -- Daniel-Constantin Mierla http://www.asipto.com/
_______________________________________________ SIP Express Router (SER) and Kamailio (OpenSER) - sr-users mailing list sr-users@lists.sip-router.org http://lists.sip-router.org/cgi-bin/mailman/listinfo/sr-users
