Robert Wilton has entered the following ballot position for draft-ietf-spring-mpls-path-segment-18: No Objection
When responding, please keep the subject line intact and reply to all email addresses included in the To and CC lines. (Feel free to cut this introductory paragraph, however.) Please refer to https://www.ietf.org/about/groups/iesg/statements/handling-ballot-positions/ for more information about how to handle DISCUSS and COMMENT positions. The document, along with other ballot positions, can be found here: https://datatracker.ietf.org/doc/draft-ietf-spring-mpls-path-segment/ ---------------------------------------------------------------------- COMMENT: ---------------------------------------------------------------------- Hi, Thanks for this document. I found is pretty easy to read, and have a couple of very minor (editorial) comments: Nit level comments: (1) p 6, sec 3.1. PSID for Performance Measurement PSID can also be used for In-situ OAM[RFC9197] for SR-MPLS to identify the SR Path associated with the in-situ data fields in the data packets on the egress node. PSID can also be used for In-band PM for SR-MPLS to identify the SR Path associated with the collected performance metrics. Just cosmetic, but given the repetition, perhaps put the last 3 sentences in this section into a list, e.g., starting with "PSID can also be used:" (2) p 7, sec 3.4. Nesting of PSIDs Binding SID (BSID) [RFC8402] can be used for SID list compression. With BSID, an end-to-end SR path in a trusted domain can be split into several sub-paths, each sub-path is identified by a BSID. Then an end-to-end SR path can be identified by a list of BSIDs, therefore, it can provide better scalability. BSID and PSID can be combined to achieve both sub-path and end-to-end path monitoring. A reference model for such a combination in (Figure 2) shows an end-to-end path (A->D) in a trusted domain that spans three sub-domains (Access, Aggregation and Core domain) and consists of three sub-paths, one in each sub-domain (sub-path (A->B), sub-path (B->C) and sub-path (C->D)). Each sub-path is associated with a BSID and a s-PSID. As a minor nit, s-PSID is used above, but not defined until the following paragraph. Regards, Rob _______________________________________________ spring mailing list spring@ietf.org https://www.ietf.org/mailman/listinfo/spring
