Hi all,
I have a project with multiple documents within that project, and the
project has the following tree structure:
* Document 1
- Chapter 1
- Chapter 2
- Chapter 3
- etc...
* Document 2
- Chapter 1
- Chapter 2
- Chapter 3
- etc...
* etc...
In each Chapter I use "numref" to refer to figures and tables by their
numbers. I noticed that the "numref" generated numbers are cumulative over
the entire project. In other word, if Doc 1, Chapter 1 has 7 figures, then
the first figure in Doc 2, Chapter 1 starts out as Figure 8 rather than
Figure 1. Is there a way for the figure and table number to reset to 1
when there's a new "toctree"? That would seem to more intuitive but I
couldn't figure out a way to do so.
Thank you,
Chien
--
You received this message because you are subscribed to the Google Groups
"sphinx-users" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To post to this group, send email to [email protected].
Visit this group at https://groups.google.com/group/sphinx-users.
For more options, visit https://groups.google.com/d/optout.
