here's output for a drive sub-model that isn't yet in the database.
$ sudo smartctl -q noserial -x -d sat /dev/sdb > smartctl-d-sat.txt
thanks! :-)
-andrew
smartctl 6.2 2013-07-26 r3841 [x86_64-linux-3.14-1-amd64] (local build)
Copyright (C) 2002-13, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Western Digital Elements / My Passport (USB, AF)
Device Model: WDC WD10JMVW-11AJGS1
Firmware Version: 01.01A01
User Capacity: 1,000,204,886,016 bytes [1.00 TB]
Sector Sizes: 512 bytes logical, 4096 bytes physical
Rotation Rate: 5400 rpm
Device is: In smartctl database [for details use: -P show]
ATA Version is: ACS-2 (minor revision not indicated)
SATA Version is: SATA 3.0, 3.0 Gb/s (current: 3.0 Gb/s)
Local Time is: Fri Jun 13 13:52:18 2014 EDT
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
AAM feature is: Unavailable
APM level is: 128 (minimum power consumption without standby)
Rd look-ahead is: Enabled
Write cache is: Enabled
ATA Security is: Disabled, NOT FROZEN [SEC1]
Wt Cache Reorder: Unknown
=== START OF READ SMART DATA SECTION ===
SMART STATUS RETURN: incomplete response, ATA output registers missing
SMART overall-health self-assessment test result: PASSED
Warning: This result is based on an Attribute check.
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: (18720) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off
support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 2) minutes.
Extended self-test routine
recommended polling time: ( 209) minutes.
Conveyance self-test routine
recommended polling time: ( 5) minutes.
SCT capabilities: (0x7035) SCT Status supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 16
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE
1 Raw_Read_Error_Rate POSR-K 200 200 051 - 0
3 Spin_Up_Time POS--K 113 112 021 - 5308
4 Start_Stop_Count -O--CK 100 100 000 - 52
5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0
7 Seek_Error_Rate -OSR-K 200 200 000 - 0
9 Power_On_Hours -O--CK 100 100 000 - 74
10 Spin_Retry_Count -O--CK 100 253 000 - 0
11 Calibration_Retry_Count -O--CK 100 253 000 - 0
12 Power_Cycle_Count -O--CK 100 100 000 - 46
192 Power-Off_Retract_Count -O--CK 200 200 000 - 15
193 Load_Cycle_Count -O--CK 200 200 000 - 661
194 Temperature_Celsius -O---K 116 100 000 - 31
196 Reallocated_Event_Count -O--CK 200 200 000 - 0
197 Current_Pending_Sector -O--CK 200 200 000 - 0
198 Offline_Uncorrectable ----CK 100 253 000 - 0
199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 0
200 Multi_Zone_Error_Rate ---R-- 100 253 000 - 0
||||||_ K auto-keep
|||||__ C event count
||||___ R error rate
|||____ S speed/performance
||_____ O updated online
|______ P prefailure warning
General Purpose Log Directory Version 1
SMART Log Directory Version 1 [multi-sector log support]
Address Access R/W Size Description
0x00 GPL,SL R/O 1 Log Directory
0x01 SL R/O 1 Summary SMART error log
0x02 SL R/O 5 Comprehensive SMART error log
0x03 GPL R/O 6 Ext. Comprehensive SMART error log
0x06 SL R/O 1 SMART self-test log
0x07 GPL R/O 1 Extended self-test log
0x09 SL R/W 1 Selective self-test log
0x10 GPL R/O 1 NCQ Command Error log
0x11 GPL R/O 1 SATA Phy Event Counters
0x80-0x9f GPL,SL R/W 16 Host vendor specific log
0xa0-0xa7 GPL,SL VS 16 Device vendor specific log
0xa8-0xb6 GPL,SL VS 1 Device vendor specific log
0xb7 GPL,SL VS 38 Device vendor specific log
0xbd GPL,SL VS 1 Device vendor specific log
0xc0 GPL,SL VS 1 Device vendor specific log
0xc1 GPL VS 93 Device vendor specific log
0xe0 GPL,SL R/W 1 SCT Command/Status
0xe1 GPL,SL R/W 1 SCT Data Transfer
SMART Extended Comprehensive Error Log Version: 1 (6 sectors)
No Errors Logged
SMART Extended Self-test Log Version: 1 (1 sectors)
Num Test_Description Status Remaining LifeTime(hours)
LBA_of_first_error
# 1 Short offline Completed without error 00% 74 -
# 2 Extended captive Interrupted (host reset) 90% 73 -
# 3 Extended captive Interrupted (host reset) 90% 3 -
# 4 Extended offline Interrupted (host reset) 40% 3 -
# 5 Conveyance offline Completed without error 00% 0 -
# 6 Short offline Completed without error 00% 0 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
SCT Status Version: 3
SCT Version (vendor specific): 258 (0x0102)
SCT Support Level: 1
Device State: Active (0)
Current Temperature: 31 Celsius
Power Cycle Min/Max Temperature: 23/31 Celsius
Lifetime Min/Max Temperature: 20/47 Celsius
Under/Over Temperature Limit Count: 0/0
SCT Temperature History Version: 2
Temperature Sampling Period: 1 minute
Temperature Logging Interval: 1 minute
Min/Max recommended Temperature: 0/60 Celsius
Min/Max Temperature Limit: -41/85 Celsius
Temperature History Size (Index): 128 (55)
Index Estimated Time Temperature Celsius
56 2014-06-13 11:45 36 *****************
... ..( 27 skipped). .. *****************
84 2014-06-13 12:13 36 *****************
85 2014-06-13 12:14 35 ****************
86 2014-06-13 12:15 35 ****************
87 2014-06-13 12:16 35 ****************
88 2014-06-13 12:17 36 *****************
89 2014-06-13 12:18 35 ****************
90 2014-06-13 12:19 36 *****************
91 2014-06-13 12:20 35 ****************
... ..( 2 skipped). .. ****************
94 2014-06-13 12:23 35 ****************
95 2014-06-13 12:24 ? -
96 2014-06-13 12:25 23 ****
97 2014-06-13 12:26 24 *****
98 2014-06-13 12:27 24 *****
99 2014-06-13 12:28 25 ******
100 2014-06-13 12:29 26 *******
101 2014-06-13 12:30 27 ********
102 2014-06-13 12:31 27 ********
103 2014-06-13 12:32 28 *********
104 2014-06-13 12:33 29 **********
105 2014-06-13 12:34 30 ***********
106 2014-06-13 12:35 30 ***********
107 2014-06-13 12:36 30 ***********
108 2014-06-13 12:37 31 ************
109 2014-06-13 12:38 31 ************
110 2014-06-13 12:39 32 *************
111 2014-06-13 12:40 33 **************
112 2014-06-13 12:41 33 **************
113 2014-06-13 12:42 33 **************
114 2014-06-13 12:43 34 ***************
115 2014-06-13 12:44 34 ***************
116 2014-06-13 12:45 35 ****************
... ..( 3 skipped). .. ****************
120 2014-06-13 12:49 35 ****************
121 2014-06-13 12:50 ? -
122 2014-06-13 12:51 23 ****
123 2014-06-13 12:52 24 *****
124 2014-06-13 12:53 24 *****
125 2014-06-13 12:54 24 *****
126 2014-06-13 12:55 25 ******
127 2014-06-13 12:56 26 *******
0 2014-06-13 12:57 26 *******
1 2014-06-13 12:58 26 *******
2 2014-06-13 12:59 27 ********
... ..( 4 skipped). .. ********
7 2014-06-13 13:04 27 ********
8 2014-06-13 13:05 28 *********
... ..( 11 skipped). .. *********
20 2014-06-13 13:17 28 *********
21 2014-06-13 13:18 29 **********
... ..( 9 skipped). .. **********
31 2014-06-13 13:28 29 **********
32 2014-06-13 13:29 30 ***********
... ..( 18 skipped). .. ***********
51 2014-06-13 13:48 30 ***********
52 2014-06-13 13:49 31 ************
... ..( 2 skipped). .. ************
55 2014-06-13 13:52 31 ************
SCT Error Recovery Control command not supported
Device Statistics (GP Log 0x04) not supported
SATA Phy Event Counters (GP Log 0x11)
ID Size Value Description
0x0001 2 0 Command failed due to ICRC error
0x0002 2 0 R_ERR response for data FIS
0x0003 2 0 R_ERR response for device-to-host data FIS
0x0004 2 0 R_ERR response for host-to-device data FIS
0x0005 2 0 R_ERR response for non-data FIS
0x0006 2 0 R_ERR response for device-to-host non-data FIS
0x0007 2 0 R_ERR response for host-to-device non-data FIS
0x0008 2 0 Device-to-host non-data FIS retries
0x0009 2 2 Transition from drive PhyRdy to drive PhyNRdy
0x000a 2 2 Device-to-host register FISes sent due to a COMRESET
0x000b 2 0 CRC errors within host-to-device FIS
0x000f 2 0 R_ERR response for host-to-device data FIS, CRC
0x0012 2 0 R_ERR response for host-to-device non-data FIS, CRC
0x8000 4 3737 Vendor specific
------------------------------------------------------------------------------
HPCC Systems Open Source Big Data Platform from LexisNexis Risk Solutions
Find What Matters Most in Your Big Data with HPCC Systems
Open Source. Fast. Scalable. Simple. Ideal for Dirty Data.
Leverages Graph Analysis for Fast Processing & Easy Data Exploration
http://p.sf.net/sfu/hpccsystems
_______________________________________________
Smartmontools-database mailing list
Smartmontools-database@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/smartmontools-database
