Hi Fritz,
This Wiki page gives a discussion of how to configure pam_slurm_adopt
correctly:
https://wiki.fysik.dtu.dk/Niflheim_system/Slurm_configuration/#pam-module-restrictions
IHTH,
Ole
On 4/9/26 05:44, Ratnasamy, Fritz via slurm-users wrote:
Hi,
We have blocked ssh to nodes where users do not have a running job.
However, when there is a running job, a user can ssh to that node and use
more than the slurm resources allocated on that node. Am I missing something?
I usually request an interactive session of 2GB. I then open another
terminal and ssh to the node where the interactive session runs. I
allocated a 4GB R variable on the node where I just ssh but this does not
error out.
Additionally, if I end my interactive session, the ssh connection still
lives which I believe should not happen.
--
Ole Holm Nielsen
PhD, Senior HPC Officer
Department of Physics, Technical University of Denmark
--
slurm-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
