I expect that as the ppm levels increase the losses also increase. Do you have any idea if the efficiency of the process is linear or non-linear? My feelings are that it is non-linear. Many people here seem to feel that 20 ppm is approaching the maximum concentration level achievable with this process, at least without wasting large amounts of silver.
Also, if you are producing any colloids or compounds which are not acting as ions which would be measurable with the conduction type testers, you would not measure them unless you are using an appropriate measurement technique. Do you end up with any residues? Dan -----Original Message----- From: Marshall Dudley [mailto:[email protected]] Sent: Friday, September 15, 2006 9:53 AM To: [email protected] Subject: Re: CS>Faraday Calculator Interestinly my flow through process with polarity reversal and stirring is only about 35% efficient. The faraday calculator says I am producing 56.7 ppm, but measurements indicate I am producing right at 20 ppm. Marshall Dan Nave wrote: > The Faraday calculator can be found at this link and downloaded. > It works great! > > http://www.silvermedicine.org/faradaycalculator.html > > Dan > -- The Silver List is a moderated forum for discussing Colloidal Silver. Instructions for unsubscribing are posted at: http://silverlist.org To post, address your message to: [email protected] Address Off-Topic messages to: [email protected] The Silver List and Off Topic List archives are currently down... List maintainer: Mike Devour <[email protected]>
