Hi, I got started by using this below, that I got off the net. I use a 15Vdc
1Ma power supply (my csanner went dead) and #12 .9999 wire. I have got good
batchs each time.
tomy thomson writes:
Hi All, does anybody have easy to read instructions on how to build a colloidal silver generator????
regards,
Tomy Bought to you from Jeff at [email protected]>
1. Buy a 6 volt DC transformer for about 5 clams. Better yet, pick up one
at a flea market for .50. The current doesnt matter as this method uses
less than one ma.
2. Clip the connector off the end of the wire.
3. Get two alligator clips from Radio Shack for a buck.
4. Carefully separate the two wires. Strip the insulation off for about 1
inch.
5. Connect each lead to the clip.
6. You need two electrodes. Dont waste $15.00 for ¼ oz. pieces of
silver wire. Go to a any coin store and buy two Canadian Maple Leafs for
about $6.50 ea. Each has 1.2 oz. of .9999 pure silver, enough to make more
CS than you will ever use.
7. Buy a gallon of distilled water for about .70.
8. Buy a tiny fish tank bubbler machine for about 8 bucks.
They will have the neoprene tubing as well. You will need about two feet.
9. Be sure the coin is squeaky clean. Clamp them to opposite sides of an
8 oz. glass of distilled water.
10. Place the tubing to the bottom of the glass.
11. Fill the glass with distilled water ONLY up to the bottom of the clips.
One does not want the metal, from the clips, in contact with the water, only
the coins.
12. Plug in the little transformer and oxygenation machine.
13. Run for about five hours.
14. Carefully remove the coins. There will be residue on them and you dont
want that in the solution. For even more purity, use the neoprene tubing
and siphon the solution into a clean glass/or plastic container. (In these
parts a siphon hose is referred to as an Arkansas credit card.)
15. Keep the CS out of sunlight in an air tight bottle.
16. Clean the coins thoroughly preparing for the next batch.
Now you have high quality CS in about 5 PPM. Some scoundrels claim their CS
is 100-800 PPM. This is rubbish.
At such concentrations the particles would agglomerate forming much larger
particles. Basic chemistry. Last night I spoke with Frank Key, the
scientist who owns the laboratory. He observed, You have stumbled on to a
fine way to make CS. He did state that the potency would diminish over
time and suggested that one make a new batch every fortnight. Considering
that costs you nothing it makes sense.He said the secret was the low voltage
and the fish pump.  I thought it was due to more oxygen in the water.
He stated it was because of the introduction of carbon dioxide, explaining
in chemical terms which were over my head. The fish pump in 100% vital to
the process.
Yours Hank.
Very Interesting Sites
http://www.babelmagazine.com
http://hdka.myecom.net/ct/ct.htm
http://hdka.stormpages.com/indexf.html
http://www.goingplatinum.com/member/hdka
http://www.babelmagazine.com/wing.html
http://www.1heluva.com/cgi-bin/join.cgi?refer=17214
Now MyECom FreeMail gives you what you've been asking for.
More storage space (10MB), large attachments that get delivered,
WEB, IMAP, POP3 and SMTP access at no extra charge,
Calendar, spell checker, mail filtering and auto-responders.
http://freemail.myecom.net
--
The silver-list is a moderated forum for discussion of colloidal silver.
Instructions for unsubscribing may be found at: http://silverlist.org
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour <[email protected]>
