Chunky Style Test Setup:
Kepco power supply; 0-100 volt, 0-1A Micronta DMM 22-194 Water Glass apx 3/4 full of Alhambra distilled water. Apx 10 oz. 68 deg. F. 14 AWG .999 fine silver wire 1 1/2" spaced. About 4" in water. About 1/2" from bottom of glass. Hit electrodes with 100 volts DC. Lots of activity started after about 15 min. Yellow brown clouds streaming off of the positive electrode. After a while, too cloudy to see electrode. Long black crystals streaming off of the negative electrode. Breaking off at about 1/2" and falling to the bottom of the glass. Tried cleaning electrodes at first but gave up after a few times. Things just going too fast. After an hour I cleaned the electrodes again. I ran the CS twice through coffee filters. Both filters had sediment. The solution is translucent. Measured the following: Current at 100 volts - 27 mA. Resistance - 6K Capacitance - 81 nF Interesting note. * The bottom of the glass was covered with bubbles but there were no dark stains as previously experienced with lower voltages and currents. I'll give it some time to settle and then try and get a Specific Gravity reading. -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>
