In a message dated 4/29/2012 10:37:43 A.M. Eastern Daylight Time,
[email protected] writes:
How does one receive instruction in the technique? Are there..."studies"?
Thank you for that info.
Hi Jim, I used it & let Bg know on the electricgermkiller sit.--It was
put in the archive with my instructions. She asked for pictures of how I
built it but I never took any & sent them..I should but it is so easy-----I
took about 6-8 inches of lamp wire---pulled it in half----cleaned the rubber /
plastic on each end of both wires--{ about 3/4 inches } I soldered one
end of one wire to the pos. post on the battery & one end of the other wire
on the negative end.... On the other bare ends I wrapped a small piece of
cotton cloth. { I used a needle & thread to keep it in place | I soaked
the cloth end of each wire in distilled water-----Put the cloth end of one
wire in my mouth as close to the abscess as I could get it & the other wire
outside on the big bump on my jaw......I help them in place for 5 mins.
then switched positions ---inside wire out * outside wire in {thus changing
the polarity } & held it for 5 mins. .....
I did this in the evening before bed time..rinsed my mouth with
hydrogen peroxide / distilled water & then CS /EIS... I did the same thing
the
next morning & again in the evening....The next morning when I got up the
swelling was almost gone & no more problems since...This was several months
ago....NO- you can't feel a thing as far as electric current passing through
the jaw... I even used it to cure my Grandson's cold sore & an infected
big toe.... Good luck--Lois
