alan, thanks for the quick response. your response prompted me to go back and re-read what archives that i have. it was a good learning event, i had several understandings that were just a little off the mark. i thank you a lot.
will keep crunching numbers, trying to find the effective dose after encapsulation for lysine, proline and d3.
and if anyone else on the list here, has any info on protocols for curcumin, alpha lipoic acid, and methl-b12, that sure would be great. thanks, again, alan jim
Jan 19, 2010 10:52:35 AM, [email protected] wrote:
Jan 19, 2010 10:52:35 AM, [email protected] wrote:
BTW, over on the Vitamin C Foundation forums I found some posts discussing Lipo-C, and there was a copy of a letter from Livon Labs indicating that 100% of the vitamin C used in their Lipo-C product is sodium ascorbate (ie. no ascorbic acid). Livon Labs suggested that using AA was a bad idea because the Lipo-C gets into your circulation very efficiently, and the AA would raise the acidity of your blood, which could be a bad thing over time.-- The Silver List is a moderated forum for discussing Colloidal Silver. Instructions for unsubscribing are posted at: http://silverlist.org To post, address your message to: [email protected] Address Off-Topic messages to: [email protected] The Silver List and Off Topic List archives are currently down... List maintainer: Mike Devour
Alan
On Tue, Jan 19, 2010 at 12:37 PM, Alan Jones <[email protected]> wrote:
Jim, to make sodium ascorbate from ascorbic acid (AA) and baking soda (BS), you should use a 2-to-1 ratio of AA to BA. So 1.5T of AA would require 0.75T of BS. What you are doing will result in 0.75T of BS remaining in the solution, which is fine, I guess, but it doesn't seem what you are intending. ("T" == tablespoon)
Alan
