The 2 instances ( Davis, Ecowitt ) run without problems with the season
skin. Davis shows the soil moisture in "*cb*" and Ecowitt in "*%*".
Unfortunately, I can only enter cb or % in the skin. Is there a solution so
that the correct unit is displayed depending on the station?
Joachim
Rich Bon
Happy new year forum!
I have my WXT520 displaying data on the weewx web page in my bench test. I
used the WXT520 driver sourced from
https://github.com/matthewwall/weewx-wxt5x0.
For my bench test, I borrowed a Vaisala USB data configuration cable. I
configured the WXT20 to send data in sdi12 f
There are a couple of ways you can handle this but the solution really
depends on what you are trying to do. Do you have two separate Seasons
suites (one for vantage and one for gw1000) or do you have a single Seasons
suite display data from both stations?
Gary
On Tuesday, 4 January 2022 at 19
As far as question #2, have you wired to the screw-attached green wiring
block INSIDE the base of the WXT and run a cable out through the
gland-seal and attached that to your SDI interface to your computer to
monitor the data stream? If not, I can look to see if I can find the
pin-out in one
I am not sure what do you mean with a single Season suite.
Weewx was running with a Davis station. I only copied these weewx.conf
twice -> davis.conf and ecowitt.conf
and have kept the only one Season skin. ( = single Season suite ?)
Joachim
gjr80 schrieb am Dienstag, 4. Januar 2022 um 12:46
You have two instances of WeeWX running; one running the vantage driver and
one running (I presume) the gw1000 driver. Does the vantage instance use
the Seasons skin to produce a set of web pages displaying vantage data
only? Likewise for the gw1000 instance, does it use the Seasons skin to
pro
Hi all,
my current WeeWX installation is running on a Raspberry Pi3 and it'S
working perfect.
Now i wanted to change the device and installed WeeWX from scratch on a new
Raspberry Pi 4.
My weather station is an EcoWitt HP1000 pro, i am using the interceptor
driver for it.
I changed the IP ad
Hi all,
my current WeeWX installation is running on a Raspberry Pi3 and it'S
working perfect.
Now i wanted to change the device and installed WeeWX from scratch on a new
Raspberry Pi 4.
My weather station is an EcoWitt HP1000 pro, i am using the interceptor
driver for it.
I changed the IP ad
On Tuesday, January 4, 2022 at 1:01:42 PM UTC-8 uwe.sc...@gmail.com wrote:
> Any idea where to start looking at it?
>
>
As always, start with your system logs. Set debug=1 and restart weewx or
run weewx interactively.
(https://weewx.com/docs/usersguide.htm#Running_directly)
I can only guess
