Dear Neale,
Thanks for taking time and answer in details.
Answer comments inline.
On Thu, Jul 25, 2019 at 12:38 PM Neale Ranns (nranns)
wrote:
>
>
> Hi Brayan,
>
>
>
> First let’s discuss a bit your config and your objectives:
>
>
>
> acl ID 0 permit { any }
>
> set int ip addr GigabitEthern
Dear Neale,
I have tried to config vpp based on your proposed configuration and after
apply this command "abf policy add id 9001 acl 0 via ip4-lookup-in-table
42", a Segfault is happened.
I'm using vpp v19.08-rc0~698-g1f50bf8fc (master branch). also, I checked it
on vpp 19.04 and the result was sa
Hi Florin,
I simplified the application. It sends the request and reads all the data from
the server using the 8 KB buffer. The fifo size is set to 8 KB. In the attached
dump [1] you can see that in packet number 14 there will be an overflow of the
size of the tcp window. My application reports
Hi Max,
Inline.
> On Jul 28, 2019, at 10:47 AM, Max A. wrote:
>
> Hi Florin,
>
> I simplified the application. It sends the request and reads all the data
> from the server using the 8 KB buffer. The fifo size is set to 8 KB. In the
> attached dump [1] you can see that in packet number 14 th
Hi Guys,
I'm trying to connect a vpp inside a host to a vpp which is running inside a
lxc container on a linux machine. I am going to do that via vhost-virtio-user.
The problem is that after I create the vhost and virtio-user, the output of the
"show vhost-user interfaces" command on the host vp
[Edited Message Follows]
Hi,
I'm trying to extend the usage of the following configuration to use iperf:
https://github.com/CiscoDevNet/iOAM/tree/master/scripts/vpp_sandbox/example/simple-ip6
The current problem is with the acls. Which are defined this way:
set ioam-trace profile trace-type 0x
The debug CLI was replaced by
set logging class vhost-user level debug
Use show log to view the messages.
Did you configure 1GB huge on the container? It used to be that dpdk virtio
requires 1GB huge page. Not sure if it is still the case nowadays. If you use
VPP 19.04 or later, you could try VP
Hi vpp-dev
When I add an abf policy and then add a route to the same gateway, a SIGSEGV
will appear.
These are the steps to generate the problem:
First setup interfaces:
vppctl set int state GigabitEthernet3/0/0 up
vppctl set int state GigabitEthernet4/0/0 up
vppctl set int ip address GigabitEther
