I have tried to adjust the num-mbufs to a value higher than 42 and this
resulted in daemon crash about 1.3 minutes after starting it.
This is happening on
-vpp v18.04-rc0~218-g07510dd
-CentOS 7.4 - 4.15.0-1.el7.elrepo.x86_64
[Edited Message Follows]
I managed to get this working with all 8 x 10G interfaces. it seem that the
issue was dpdk_mbuf value which was a bit too low.
I manages to get this working with all 8 x 10G interfaces. it seem that the
issue was dpdk_mbuf value which was a bit too low.
I started disabling dpdk on 3 of the working ports and now i got the ones that
were not working before in working state. So it look like i might reach some
resource limitation when enabling more than 5 interfaces at the same time.
I will need to find out what resource was falling short now. Wis
Hi All,
I am very new to VPP. I basically just compiled it, assigned some interfaces
and was ready to start testing performance improvements over kernel with an
ixia box.
All in all i want to use 8 x 10G interfaces in my setup and pass through them a
total of ~36Gbps of traffic but i got stuc
