Hello!
I have been doing a simple test where an impulse (with a rather small duty
cycle) is sent over a (short) wire and then captured by two N32x boards
synchronized with White Rabbit. The B210 has a sampling rate of 4 Msps, while
I’ve tried using both 10 Msps and 5 Msps for the N32x (with the
Could this be an issue related to automatic DC bias calibration? If you are
using a "DC" pulse (that is, at 0 Hz relative to the LO), perhaps you are
seeing effects from DC bias cancellation. You can either turn off this
calibration using the appropriate "args" at startup or you could request an
L
Hello Rob,
Thanks for your reply! Actually I was observing the same phenomenon, though
significantly less pronounced, with a sine wave. In the dsp-related forum
they’ve pointed me to the fact that it could be due to the sampling phase
(emitter and receivers do not share the LOs), I still have t
Hi,
I am trying to install rfnoc usiing pybombs per
https://kb.ettus.com/Getting_Started_with_RFNoC_Development#Create_the_development_environment_manually
It seems to fail in the gnuradio portion, as shown below. I have found
references to issues like gnuradio branch should be maint-3.7, b
On 2022-03-16 12:05, Caffrey, Michael Paul via USRP-users wrote:
Hi,
I am trying to install rfnoc usiing pybombs per
https://kb.ettus.com/Getting_Started_with_RFNoC_Development#Create_the_development_environment_manually
It seems to fail in the gnuradio portion, as shown below. I have found
From: Marcus D. Leech
Sent: Wednesday, March 16, 2022 10:15 AM
To: usrp-users@lists.ettus.com
Subject: [USRP-users] Re: pybombs install of rfnoc onto ubuntu 20.04 lts
On 2022-03-16 12:05, Caffrey, Michael Paul via USRP-users wrote:
Since this is a pybombs install, you need to run setup_env.s
On 2022-03-16 12:41, Caffrey, Michael Paul via USRP-users wrote:
*From:* Marcus D. Leech
*Sent:* Wednesday, March 16, 2022 10:15 AM
*To:* usrp-users@lists.ettus.com
*Subject:* [USRP-users] Re: pybombs install of rfnoc onto ubuntu
20.04 lts
On 2022-03-16 12:05, Caffrey, Michael Paul via USRP
Dear community,
I have purchased a few LP0965 Antennas
(https://www.ettus.com/all-products/lp0965/) because I would like to do
a 5G transmission at 3.5 GHz (using OpenAirInterface).
Is there any guidelines that I can follow for deployment? For example,
in the link it mentions that "The SMA c
On 2022-03-16 17:34, Giuseppe Santaromita wrote:
Dear community,
I have purchased a few LP0965 Antennas
(https://www.ettus.com/all-products/lp0965/) because I would like to
do a 5G transmission at 3.5 GHz (using OpenAirInterface).
Is there any guidelines that I can follow for deployment? For
