[U-Boot] [PATCH v2] mmc: i.MX6: fsl_esdhc: Define maximum bus width supported by a board

2013-03-25 Thread Abbas Raza
From: Abbas Raza Maximum bus width supported by some i.MX6 boards is not 8bit like others. In case where both host controller and card support 8bit transfers, they agree to communicate on 8bit interface while some boards support only 4bit interface. Due to this reason the mmc 8bit default mode

Re: [U-Boot] [PATCH] mmc: mx6qsabrelite: fsl_esdhc: Define maximum bus width supported by SabreLite board

2013-03-25 Thread Abbas Raza
Hi, On 03/21/2013 09:17 PM, Eric Nelson wrote: > Thanks Abbas, > > Tested-by: Eric Nelson > > Note that the board settings also apply to nitrogen6x and wandboard > if you want to expand the patch a bit: > > > http://git.denx.de/u-boot.git/?p=u-boot/u-boot-imx.git;a=blob;f=board/boundary/

[U-Boot] [PATCH] mmc: mx6qsabrelite: fsl_esdhc: Define maximum bus width supported by SabreLite board

2013-03-21 Thread Abbas Raza
From: Abbas Raza Maximum bus width supported by SabreLite board is not 8bit like all other mx6q specific boards. In case where both host controller and card support 8bit transfers, they agree to communicate on 8bit interface while boards like the SabreLite support only 4bit interface. Due to

[U-Boot] [PATCH] mmc: mx6qsabrelite: fsl_esdhc: Define maximum bus width supported by SabreLite board

2013-03-21 Thread Abbas Raza
From: Abbas Raza Maximum bus width supported by SabreLite board is not 8bit like all other mx6q specific boards. In case where both host controller and card support 8bit transfers, they agree to communicate on 8bit interface while boards like the SabreLite support only 4bit interface. Due to

[U-Boot] MIPS malta platform support in u-boot

2011-08-29 Thread Abbas Raza
available for this platform. Thanks ! Abbas Raza ___ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot

[U-Boot] imx31 USB OTG support?

2010-10-25 Thread Abbas Raza
Hello, Is there any support in uboot for USB OTG of imx31? I am trying to configure USB OTG in device mode for imx31. Any one worked on it or any ideas. Any help will be appreciated. Thanks -- Abbas Raza ___ U-Boot mailing list U-Boot@lists.denx.de