Am Sat, 11 Aug 2012 20:54:04 +0200
schrieb "Olaf Devik" :
> As to operating system story is as follows:
>
> 1 Had kubuntu 10.10 working with tlf all ok.
> 2 Updated to kubuntu 12.04 after a number of network connection
> issues. Did a clean new install.
> 3 Installed cqrlog which installs the ham
Thanks Thomas,
this was happening to me as well ( FT-950 ) but was only a minor
annoyance so had I not until now done anything about it. I have added
the appropriate line to my config file and all is well.
cheers, Graham ve3gtc
On 12-08-11 06:31 PM, Thomas Beierlein wrote:
Hi Olaf,
Am S
Hi Olaf,
Am Sat, 11 Aug 2012 08:55:05 +0200
schrieb Olaf Devik :
> My K3 combined with tlf/hamlib reads frequency/mode nicely both into
> cqrlog and to tlf and if necessary simultaneously by use of rigctld
> daemon. Some hassle to set up as I had to compile hamlib from source,
> the standard i
On Aug 10, 2012, at 7:08 AM, Olaf Devik wrote:
> I have hamlib installed and running ok with cwrlog and by checking rigctl.
>
> When setting up tlf fir compiling. /configure --enable-hamlib it claims
> hamlib can not be found.
>
> Compiling wo hamlib works ok.
>
> I need rigcontrol. What to
I have hamlib installed and running ok with cwrlog and by checking rigctl.
When setting up tlf fir compiling. /configure --enable-hamlib it claims
hamlib can not be found.
Compiling wo hamlib works ok.
I need rigcontrol. What to do?
Mvh
Olaf Devik
_
I seem to have a weird problem with cwdaemon. Cwdaemon is installed as
part of cqrlogger and when checking I can find that cwdaemon is running.
Before tlf or cqrlog is started I can check the cwdaemon via nc -u
localhost 6789 - which keys the rig as planned.
When starting tlf, tlf reports that
My K3 combined with tlf/hamlib reads frequency/mode nicely both into
cqrlog and to tlf and if necessary simultaneously by use of rigctld
daemon. Some hassle to set up as I had to compile hamlib from source,
the standard install were not found by tlf unless hamlib was compiled.
My question is a
