Hi All,
Finally, the kamalio was installed on the Solaris 10 sparc and I can start it
with the 'kamctl start', and it is running as showed below. However I cann't
add user by using the kamctl, it always says the user already exists. And
actually the susbciber table is still empty in mysql.
thanks!
...but does it even make sense what I'm trying to do? I mean, at what
point in the cfg would I tell it that if it's choosing a specific gw,
it needs to substitute the IP with a domain name...a new $rd?
//Anders
On Wed, Jun 9, 2010 at 12:28 PM, Klaus Darilion
wrote:
> $d_ means destinati
$d_ means destination URI (DURI). The DURI is used only for routing
purposes and ist not reflected in the SIP message. You want to use $d_
which means the request URI (RURI).
$rd = "domain.com"
regards
klaus
PS: both, ruri and duri are read/write
Am 09.06.2010 18:23, schrieb Anders:
Hi,
I
Hi,
I have a carrier who insists and have configured their system so they
can receive INVITEs to their domain name only, and not the IP. I
cannot configure the gw for anything but IPs, but thought that I might
be able to replace the IP address in the cfg. So I tried with setting
$dd = "domain.com"
> If that's really your complete Kamailio config, it's missing a number
> of critical checks and handlers, such as loose_route(), which handles
> sequential (in-dialog) requests differently from initial requests due
> to the presence of a Route: header and a To header tag.
>
> You can't just stick
Am 09.06.2010 07:29, schrieb Information:
Hi,
I want a setup in which each communication will be done peer to peer.
will either rtpproxy or mediaproxy satisfy that condition? If not, can i
configure a STUN server and do it?
It depends on the NAT. If the NAT is a symmetric NAT you need a medi
