Hi everybody,
> I don't mean to be insulting, but did you remember to change
> snapscan.conf to point to the newer version of the firmware file?
no, I stumbeld over that, but realized it and fixed it. But it didn't help...
But I think it would be unfair to blame the software instead of admitting m
Hi everybody,
I replaced the firmware 1.14 with the 1.16 I received (thanks Simon and Ken),
but I have no change in the behaviour of my scanner. When I address the
transparency unit, it runs into a loop. The debug ends repeating the attached
block below over and over.
Any Ideas, any advice?
th
Hi,
>
> Mine is version 1.14, dated 20040402, according to the end of the
> firmware file.
>
> Used to work fine for transparencies with 1.0.15.
I've got the 1.14/20040402 as well, that is not working for me with the 1.0.15
backend.
I just downloaded the 1.0.16 sources, and hope to get it compi
> Maybe it'd be interesting to compare the firmwares used.
ok, here is mine:
esfw41.bin -> transparency does not work at all with 1.0.15 sane backend,
using the snapscan interface.
Is the difference in the firmware-versions in the filename or something
"inside" the firmware? I think my filedate
Hi Philippe,
I use the 2480 with the following setup:
- base is a SuSE 9.2, i.e. the libusb-variant and not the kernel scanner
module
- I recompiled the 1.0.15 backend from source, but had a bit fiddeling around
with installation, it works best to delete everything installed by the distro
and m
Hi,
> > > is there any chance, to get the transparency-adaptor of the
> > > mentioned scanner working?
> > > Would it be of any help to post debug-output to the list?
> >
> > It works out of the box, AFAIK.
>
> Hmmm. so why it is still on 'unsupported' list??
> http://www.sane-project.org/unsupport
Hi,
>
> It works out of the box, AFAIK.
at least not for me - maybe I'm wrong at some point?
I didn't work in xsane, nor in kooka, nor with scanimage on the commandline.
>From what I can see in this debug-output, it gets into a countdown waiting or
the device to get ready, but it gets stuck at
Hi everybody,
is there any chance, to get the transparency-adaptor of the mentioned scanner
working?
Would it be of any help to post debug-output to the list?
thanks,
Reinald
--
Visit the TR-Competition!
Info on http://www.tr-competition.de
