www.millersolar.com
CA Lic. 773985
*From:* RE-wrenches [mailto:re-wrenches-boun...@lists.re-wrenches.org] *On
Behalf Of *John Blittersdorf
*Sent:* Monday, October 19, 2020 6:32 AM
*To:* RE-wrenches
*Subject:* Re: [RE-wrenches] Mixing Outback 100 series C with old FX system
William, I don’t think the
We use the FM 100, but not Outback inverters. We have one Mate 3 meter
on the truck, we use it to program the controller, and then pull the
meter. It holds all its programming, and this saves the customer
$600.00. They can monitor with the amp hr meter (Magnum or Trimetric)
Its not the best
Jay, thanks yes that is correct, it was a jumper to allow the FNDC to work.
I had no trouble connecting a Mate3s to the FM100-AFCI.
Brad
On Mon, Oct 19, 2020 at 12:37 PM Jay wrote:
> On page 71 there is a small note about hooking up a FNDC without an
> inverter.
>
> It might be what Brad was me
On page 71 there is a small note about hooking up a FNDC without an inverter.
It might be what Brad was mentioning.
Jay
> On Oct 19, 2020, at 12:48 PM, Dan Fink wrote:
>
>
> Maybe Brad is referring to the GFDI jumper or the RSS jumper? I don't know of
> a jumper to activate comms with t
Maybe Brad is referring to the GFDI jumper or the RSS jumper? I don't know
of a jumper to activate comms with the Mate 3S.
The former is for bonding and you remove it if you use an external GFDI,
like a Midnite GFCI in a Midnite MNDC enclosure. It's the little black wire
with 2 red spade connector
Hello All
Hi William
I just tried my Mate3S in to my FM100AFCI and it does see the FM100 and all the
screen are available.
Here is a screen shot from the Quick Start Guide
http://www.outbackpower.com/downloads/documents/charge_controllers/flexmax_100_afci/fm100_afci_qsg.pdf
There are 2 ports on th
William, I don’t think the fm100 will be visible unless you reboot the
whole system with inverter attached to port 1 of hub, mate3s attached to
mate terminal in hub and fm100 plugged into port 2 of hub. I’ve done this
numerous times and you can program the fm 100. However, I have never left
an fm
I think there is a jumper in the FM100 that will allow the Mate3s to
communicate with it. I don't remember off hand where it is and am not at a
computer with that info, but maybe this will prompt a look at the manual to
see if they mention it.
Brad
On Fri, Oct 16, 2020 at 11:11 PM William Miller
Friends:
I installed a Flexmax 100 today in a dual FX system circa 2003. The system
has an oval Mate and it is no surprise the old Mate does not communicate
with the FM100 as this was made clear from the literature.
I plugged in a new Mate3S directly into the FM100 hoping to connect and see
9 matches
Mail list logo
