On 03/26/2012 02:54 PM, Sudhir Harwalkar wrote:
Hello Sudhir,
> Please find the modified EAP-PEAPv0 file, please check once whether whatever
> changes I made are correct or not, please see the error message attached with
> this peaperror.PNG.
Try defining your using slash '/' instead of backsl
Hi Heikki,
Am 2012-03-22 17:16, schrieb Heikki Vatiainen:
> On 03/21/2012 12:11 PM, Alexander Hartmaier wrote:
>
>> Now that our dot1x and WLAN Radiator needs to check three different crls
>> I've looked into a better solution for refreshing them.
>> While reading Radius::TLS I've stumbled over th
Hello all
I use a PEAP ,MSCHAPV2 auth set up , going to an AD server. I will send on
config file if needed , but hopefully it's a simple fix
I get the error EAP Nak desires type 26. From Google and everything else I
don't get much. Can anyone send me on my way,
Regards
Richard Dunn
I found this on a cisco book
VALUE EAP-Type MS-EAP-Authentication 26
Now the problem is I use ms-chap v2 and it works fine. So why am I seeing
this message
Thanks for any ideas
Richard
From: radiator-boun...@open.com.au [mailto:radiator-boun...@open.co
Hi,
>I use a PEAP ,MSCHAPV2 auth set up , going to an AD server. I will send on
>config file if needed , but hopefully it’s a simple fix
sending the obfuscated config might help.. type 26 is EAP MS-CHAP-V2 (a slightly
different beast to plain MSCHAPv2) - your config needs to be configured
On 03/26/2012 05:55 PM, Richard Dunne wrote:
> I use a PEAP ,MSCHAPV2 auth set up , going to an AD server. I will send
> on config file if needed , but hopefully it’s a simple fix
> I get the error *EAP Nak desires type 26. *From Google and everything
> else I don’t get much. Can anyone send me o
An EAP NAK is usually issued by the Client Side when the server initiates
the connection with a method and the client is not configured from it. In
the NAK the client sends the EAP Method type it supports/is configured for.
>From the Log snipped it seems that the client is setup for EAPMsChapv2
ins
I modified the file according to your changes, that works fine.
There are some queries:
1. In the config file if I mentioned Auth PORT and ACCTPORT then it's taking as
1645 and 1646, and I tried with the command line means I gave authport and
acctport its taking properly.
2. I gave UserName and
