Signed-off-by: Alexander Couzens
---
target/linux/ramips/base-files/etc/diag.sh | 3 +
.../etc/hotplug.d/firmware/10-rt2x00-eeprom| 1 +
target/linux/ramips/base-files/lib/ramips.sh | 3 +
.../ramips/base-files/lib/upgrade/platform.sh | 1 +
target/linux/ramips/
I've seen this a lot with openocd and arm cortex-m targets. There's always lots
of finger pointing, but it's "incompatible" gdb version and gdbserver version.
It's to do with the gdbserver sending an XML memory map that your version of gdb
doesn't understand. (or at least, doesn't understand
27;
option netmask '255.255.255.0'
config 'interface' 'wan'
option 'ifname' 'ppp0'
option 'proto' '3g'
option 'service' 'evdo'
option 'device' &
On 6/8/2013 8:10 PM, Mitch Kelly wrote:
Hi,
The 703N can only supply 200mA out the USB port, Its likely this issue
is caused by the device using more power that can be supplied and the
device resetting.
TP-Link have a compatibility Martix for devices, It is based on Power
consumption, Not
brcm47xx platform with BCM5354, BARRIER BREAKER (Bleeding Edge, r36813)
i'm getting these jffs2 errors at each boot as well as system read-only
(doesn't allow to change passwd etc.)
Press the [f] key and hit [enter] to enter failsafe mode
- regular preinit -
[ 10.328000] jffs2: jffs2_scan_erasebl
