Hi!
Changing the reset config to separate, and the script to use "reset
halt" worked, now every programming works!
Here's my output. http://sem.sch.bme.hu/~akos/output.txt It was
created using reset_config trst_pulls_srst and "reset run".
If it is any help I can send the output using the fixed
Akos Vandra wrote:
> I know what TRST is, but not SRST. Would it be the "normal" chip
> reset?
Right, system reset.
//Peter
___
Openocd-development mailing list
Openocd-development@lists.berlios.de
https://lists.berlios.de/mailman/listinfo/openocd-deve
I know what TRST is, but not SRST. Would it be the "normal" chip reset?
Ákos
On 20 October 2011 11:12, Peter Stuge wrote:
> Akos Vandra wrote:
>> 1. (in reply to freddie choppin)
>> As far as I understand, reset halt is not supported on my target
>> because srst pulls trst.
>
> Note that this w
Akos Vandra wrote:
> 1. (in reply to freddie choppin)
> As far as I understand, reset halt is not supported on my target
> because srst pulls trst.
Note that this was set incorrectly for the lpc17xx chip. Double check
if the setting in openocd really actually matches your hardware. You
need to ch
I just realized I hit "reply" for all previous emails, so I did not
send them to the list. I'll copy paste them below.
I am converting the elf to bin to be able to correct the checksum
afterwards with a little tool I wrote. This way openocd does not emit
warnings about the verification failiure.
Andreas Fritiofson wrote:
> But what is the mwb 0x400FC040 0x01 doing?
MEMMAP
Bit 0 MAP Reset value 0
0 Boot mode. A portion of the Boot ROM is mapped to address 0.
1 User mode. The on-chip Flash memory is mapped to address 0.
6. Debug memory re-mapping
-
Following chip reset, a portion of the
On Wed, Oct 19, 2011 at 2:23 PM, freddie_chopin wrote:
> W dniu 2011-10-19 14:14:11 użytkownik Akos Vandra
> napisał:
> > #lpcfixchecksum takes only binary files, so
> > #make a binary file from the elf, and fix the checksum.
> > arm-eabi-objcopy -O binary $FILE tmp.bin
> > lpcfixchecksum tmp.bin
Hi guys!
I am trying to program an lpc1768 device using an oocdlink
(Ft2232-based) programmer.
Only every other programming works, which is very strange.
After the first programming, the uC seems to be in a lockup state.
After second programming, it always works as a charm.
I'm pretty much sur
W dniu 2011-10-19 14:14:11 użytkownik Akos Vandra napisał:
> #lpcfixchecksum takes only binary files, so
> #make a binary file from the elf, and fix the checksum.
> arm-eabi-objcopy -O binary $FILE tmp.bin
> lpcfixchecksum tmp.bin
On LPC2xxx you can use elf, hex of bin - no need to convert anythi
