> -Original Message-
> From: Øyvind Harboe [mailto:oyvind.har...@zylin.com]
> Sent: dinsdag 27 april 2010 1:32
> To: Nico Coesel
> Cc: openocd-development@lists.berlios.de
> Subject: Re: [Openocd-development] build openocd for arm
>
> This no longer appli
This no longer applies against origin/master.
Could you update and repost the patches?
Nit: remove commented out code.
Did you have to fix *all* those locations in jim.c?
If only some of those were necessary, then I would like to have those
split out into a separate commit.
--
Meet Zylin at
sel
> Cc: Yu Li; openocd-development@lists.berlios.de
> Subject: Re: [Openocd-development] build openocd for arm
>
> Please repost the patch if it was simply forgotten.
>
> The warning here is actually benign, but there is no way the
> compiler can know that.
>
>
>
Please repost the patch if it was simply forgotten.
The warning here is actually benign, but there is no way the
compiler can know that.
--
Meet Zylin at ESC 2010 San Jose
April 26 - 30. 2010
http://www.zylin.com/events_esc2010.html
Øyvind Harboe
US toll free 1-866-980-3434 / International
>
> Nico Coesel
>
> -Oorspronkelijk bericht-
> Van: openocd-development-boun...@lists.berlios.de namens Yu Li
> Verzonden: za 4/24/10 15:44
> Aan: openocd-development@lists.berlios.de
> Onderwerp: [Openocd-development] build openocd for arm
>
> hi,
> i want to build openocd t
namens Yu Li
Verzonden: za 4/24/10 15:44
Aan: openocd-development@lists.berlios.de
Onderwerp: [Openocd-development] build openocd for arm
hi,
i want to build openocd that can run on arm9.
i use,
$ CC=arm-linux-gcc ./configure --prefix=/opt/arm-openocd
--build=i686-pc-linux-gnu --host=arm-linux --target
Hi,
Yu Li schrieb:
> i want to build openocd that can run on arm9.
> i use,
> $ CC=arm-linux-gcc ./configure --prefix=/opt/arm-openocd
> --build=i686-pc-linux-gnu --host=arm-linux --target=arm-linux
> --enable-parport --enable-maintainer-mode
> $ make
>
> but i got the error
> arm_jtag.h: 81: err
hi,
i want to build openocd that can run on arm9.
i use,
$ CC=arm-linux-gcc ./configure --prefix=/opt/arm-openocd
--build=i686-pc-linux-gnu --host=arm-linux --target=arm-linux
--enable-parport --enable-maintainer-mode
$ make
but i got the error
arm_jtag.h: 81: error: cast increases required alignm
