I successfully recreated the zpool from scratch (it's an rsync backup of
my NAS), and then ran new rsyncs. Getting these rsyncs running was a bit
of a nightmare. Once I got a run successfully going, one drive kept
dropping out, putting the zpool offline. Well, that explained a few
problems, bot
As that link was to a post of mine, I'll play closer attention to the thread.
I don't recall the details, but in general, my recollection is that various
tools were incorrectly setting or reporting the label information.
ZFS puts labels at both ends of the disk and will get seriously befuddled
Hi, Stephan.
does this error concerns only single disks, or all disks in that pool? Also,
what does zpool imnport without actually trying to import the zpool by name
say? Usually, if a zpool is not ready for importing, zpool will list any device
of that pool with it's current status (missing,
Hi Rainer,
- Ursprüngliche Mail -
> Von: "Rainer Heilke"
> An: openindiana-discuss@openindiana.org
> Gesendet: Samstag, 18. Mai 2019 23:34:24
> Betreff: Re: [OpenIndiana-discuss] zpool import issues continued - block
> alignment
>
> Thank you.
>
&g
Thank you.
On 5/18/2019 2:26 PM, Michal Nowak wrote:
though I didn't look in to it in detail and the warning might be just a
symptom and not the actual problem..., perhaps this older thread is
relevant to your problem:
https://openindiana.org/pipermail/openindiana-discuss/2013-March/012373.
Rainer,
On 05/18/19 10:08 PM, Rainer Heilke wrote:
Hi.
Booting from the OmniOSce LTS DVD, I dropped to the shell and tried to
see if I could import my backup pool readonly. I get the "unsupported
version or features" error, and then this error prints out a few times:
WARNING: Disk '/dev/dsk/
Hi.
Booting from the OmniOSce LTS DVD, I dropped to the shell and tried to
see if I could import my backup pool readonly. I get the "unsupported
version or features" error, and then this error prints out a few times:
WARNING: Disk '/dev/dsk/c3t11d1s0, has a block alignment that is larger
than
