We use
Ethernet controller: Intel Corporation 82545EM Gigabit Ethernet
Controller (Copper) (rev 01)
Ethernet controller: Intel Corporation 82557/8/9/0/1 Ethernet Pro 100
(rev 10)
To boot I use the 82545EM card
Regards
Wim
--
Wim De Geeter
| System Administrator
| Wegener Center for Climate
Thanks, this soved it. I installed it in the chroot
Hi,
I have used fai with lenny without problems
No i try to test it with squeeze.
When I boot my first client I get an error in task partition
With Lenny the disk_config file was working fine
failog:
/FAI_ACTION: install
Performing FAI installation. All data may be overwritten!
^G^G^G
Calling ta
Hi,
I have a main server with squeeze installed.
Now I try to create a squeeze nfsroot, but when I run fai-setup i got
this error
/ERROR: No initrd installed./
the complete log file is/:
Account $LOGUSER=fai already exists.
Make sure that all install clients can
log into this account without a
Many thanks,
The most important thing I forgot :-[
Wim
Michael Goetze wrote:
Hi Wim,
My filesystem and all installed packages are installed under /target in
stead of /
Any idea what I forget
I think you forgot to reboot (and then boot from hard drive rather than
network/
Hi,
I try to start and understand how FAI works.
I have configured my first client to boot under FAI. Everything went
well but something is not really clear to me.
My filesystem and all installed packages are installed under /target in
stead of /
rootfs126M 2.6M 123M 3% /
Thanks, now it boots. I have to look further.
Hi,
I am trying to setup and test a fai-server. I followed the instructions
from http://www.informatik.uni-koeln.de/fai/fai-guide.pdf.
Now I try to boot my first client to test if dhcp and tftp is working.
I got the pxelinux.0 file from my faiserver. Get all the info from my
DHCP (ip, gateway,
