gt;
> So, replace it by a valid syntax.
>
> Signed-off-by: Mauro Carvalho Chehab
Acked-by: Oliver Hartkopp
Thanks Mauro!
Best regards,
Oliver
> ---
> Documentation/networking/can.rst | 4 ++--
> 1 file changed, 2 insertions(+), 2 deletions(-)
>
> diff --git a/Documentation/n
Hello Ramesh,
please send out a new v3 patchset to trigger the process again :-)
Best regards,
Oliver
On 04/13/2016 08:25 AM, Ramesh Shanmugasundaram wrote:
HI Marc,
Gentle reminder!
Are you happy with the open comment's disposition? I can send a next version of
patch if we have a closure on
Hi Ramesh,
On 03/11/2016 08:14 AM, Ramesh Shanmugasundaram wrote:
As we are fixing this issue in CAN dev.c, I'll remove this check in ndo_open and
set CAN_CTRLMODE_FD flag in ctrlmode & remove the flag in ctrlmode_supported in
the next v3 version of the patch.
I posted a V2 version of that
On 03/08/2016 01:48 PM, Ramesh Shanmugasundaram wrote:
>> In fact you provided a CAN driver which is "CAN-FD-only".
>
> Yes. That's the status of current submission.
>
>> We did not had that before but there's a solution for this kind of setup.
>>
>> There is a similar case with CAN_CTRLMODE_FD_
Hi Ramesh,
On 08.03.2016 09:57, Ramesh Shanmugasundaram wrote:
As you mentioned further down, when a user does this
"ip link set can0 up type can bitrate 100"
the intention is to put the controller in CAN 2.0 mode. Even if we use a status
flag or copy the data bitrate equal to the nomin
On 03/07/2016 09:32 AM, Ramesh Shanmugasundaram wrote:
> + /* Ensure channel starts in FD mode */
> + if (!(priv->can.ctrlmode & CAN_CTRLMODE_FD)) {
> + netdev_err(ndev, "enable can fd mode for channel %d\n", ch);
> + goto fail_mode;
> + }
What's the
On 03/03/2016 04:38 PM, Ramesh Shanmugasundaram wrote:
> Changes since v1:
> * Removed testmodes & debugfs code (suggested by Oliver H)
> * Fixed tx path race issue by introducing lock (suggested by Marc K)
> * Removed __maybe_unused attribute of rcar_canfd_of_table
>
> obj-$
On 03/01/2016 10:34 AM, Ramesh Shanmugasundaram wrote:
> This patch adds support for the CAN FD controller found in Renesas R-Car
> SoCs. The controller operates in CAN FD mode by default. Two test modes
> are available and can be enabled by the "rcar_canfd.testmode" module
> parameter. Refer to
