KR> fly in

2011-08-05 Thread Terry Chizek

KR> Fuel System

2011-08-05 Thread Terry Chizek
On 8/5/11, Eric Evezard wrote: > Dave, > What sort of carb/carbs system do you have.Do you have the float chamber and > needle valve shut off system such as a Zenith/Stromberg or do you have a > throttle body type such as a Posa/Ellison.? > Regards, > Eric, > South Africa > _

KR> Fuel System

2011-08-05 Thread Craig Williams
Mark, That is good info! I have the Ellison and now will add a FP gauge to the panel. Thanks Craig www.kr2seafury.com --- On Fri, 8/5/11, Mark Jones wrote: > From: Mark Jones > Subject: Re: KR> Fuel System > To: "KRnet" > Date: Friday, August 5, 2011, 10:45 AM > > .> It also has a port on

KR> Fuel System

2011-08-05 Thread Mark Jones
.> It also has a port on it for installing a Fuel Pressure sender, in case you >want to know what your pressure is. I would highly reccommend installing a fuel pressure gauge as I once had a ground wire break going to one of my Facet pumps and had I not had the pressure gauge I would not have

KR> stub wing baggage compartment

2011-08-05 Thread velocityo...@yahoo.com
The Sport Cruiser I was instructing in had them on both sides. Great idea if between the spars. Make sure it has a small drain hole in the aft bottom Because in the Sport Cruiser in rain they would fill up with water. Victor Sent from my iPhone On Aug 1, 2011, at 5:44 PM, Donald Greer wrote:

KR> Fuel System

2011-08-05 Thread Eric Evezard
Dave, What sort of carb/carbs system do you have.Do you have the float chamber and needle valve shut off system such as a Zenith/Stromberg or do you have a throttle body type such as a Posa/Ellison.? Regards, Eric, South Africa

KR> Fuel System

2011-08-05 Thread flyboybob
Dan, Congradulations on your progress! << Who knows, I might make the gathering with the Black Bird after all. >> Bob

KR> Fuel System

2011-08-05 Thread Dan Heath
What carburetor are you using. Some can use only gravity feed. I have always used the Facet with the Ellison carburetor and have never had that problem. I installed new Facet pumps for my new Ellison EFS-3A that I am using on my new Roy's Garage Corvair engine and while probably not necessary, i

KR> Flap and belly board combination.

2011-08-05 Thread Peter Diffey
Mark, Your right I really should, but as I said I wimped out as I don't want to end up spinning. Spin training isn't part of UK PPL sylabus, so I am rather nervous about getting into a situation I can't handle. I still contend that it would be better for our friend to build light with aircraf