Re: gEDA-user: Hints to get ALL rats to route

It may not have a wide-enough space to fit a trace through. Open it up and try again, if that's the case, or switch to skinnier lines(?). Phil ___ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

Re: gEDA-user: how to check for holes and pad size

Please be careful when replying to a digest; specifically, make sure you correct the subject line. > Here, I have an other question, PCB does not have circle command how can > the semicircle be constructed and wind up with open to one the side > rater than diagonal. I am try to make the TO92 foot

gEDA-user: Hints to get ALL rats to route

I have one rat that I can't get to route. Are there any tricks to get it to route? ___ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

Re: gEDA-user: geda-user Digest, Vol 27, Issue 5

> Today's Topics: > >1. how to check for holes and pad size (Vincent Onelli) >2. Re: how to check for holes and pad size (DJ Delorie) > > > -- > > Message: 1 > Date: Mon, 04 Aug 2008 09:29:46 -0400 > From: Vincent Onell

Re: gEDA-user: how to check for holes and pad size

Put the crosshair over the pin/hole and hit Ctrl-R to report on that pin/hole. ___ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

gEDA-user: how to check for holes and pad size

Hi, Is there a way to find out what size the holes and the pads are? I was not able to find that information any ware. thank you. Vinny ___ geda-user mailing list geda-user@moria.seul.org http://www.seul.org/cgi-bin/mailman/listinfo/geda-user