-BEGIN PGP SIGNED MESSAGE-
Hash: SHA1
Steve Franks wrote:
> I have another section to add to my previous post:
>
> At some point in your dealings, you may introduce a typo into a
> critical startup file, such as rc.conf, loader.conf, fstab, or
> similar, and reach the following upon rebo
I have another section to add to my previous post:
At some point in your dealings, you may introduce a typo into a
critical startup file, such as rc.conf, loader.conf, fstab, or
similar, and reach the following upon reboot:
""
"Press enter for /bin/sh:"
To recover:
0. press enter
1. cd /e
On 1/16/07, Giorgos Keramidas <[EMAIL PROTECTED]> wrote:
On 2007-01-16 15:47, Steve Franks <[EMAIL PROTECTED]> wrote:
> So, this is what I have so for. It was a bit late at night, so I
appologise
> if my tone is a bit silly at times...where do we go from here? Steve
[snip nicely written stuff
On 1/7/07, Giorgos Keramidas <[EMAIL PROTECTED]> wrote:
On 2007-01-07 08:54, Steve Franks <[EMAIL PROTECTED]> wrote:
> Apologies on not hitting the list. Alyays forget to reply-all.
No problem. I just didn't copy the list because I wasn't sure I should.
> So, I figured I'd try to fix the saf
Apologies on not hitting the list. Alyays forget to reply-all.
So, I figured I'd try to fix the safe-mode end of things on my own, and I
found a post several years old (looked like it even could have been yours)
about safemode, which doesn't show up anywhere on the freebsd site. So I
did what i
On 2007-01-07 08:54, Steve Franks <[EMAIL PROTECTED]> wrote:
> Apologies on not hitting the list. Alyays forget to reply-all.
No problem. I just didn't copy the list because I wasn't sure I should.
> So, I figured I'd try to fix the safe-mode end of things on my own,
> and I found a post severa
On 2007-01-06 10:08, Steve Franks <[EMAIL PROTECTED]> wrote:
> I have an ath0 card working fine in one system. I put it in the
> other, kldload if_ath, but no ath0. kldload appears sucessful,
> because if you try it again, if says file already present. I notice
> my pcmcia appears to show up suc
I have an ath0 card working fine in one system. I put it in the other,
kldload if_ath, but no ath0. kldload appears sucessful, because if you try
it again, if says file already present. I notice my pcmcia appears to show
up sucesfully when I boot, but I get no output on tty0 when I plug in the
