Re: IP_ONESBCAST and upcoming RELENG_4_9 freeze

On Thu, Aug 21, 2003 at 10:35:03PM -0700, Wes Peters wrote: > Your change makes it so that broadcasts sent to 255.255.255.255 will > be transmitted on all interfaces marked with a ONES_BCAST flag, right? It really is a very simple addition. It's a protocol-level socket option, so doesn't interfe

Receiving INADDR_BROADCAST packets

Hi all, Ok, the broadcast sending problem is solved, as far as I'm concerned. However, the reception problem isn't: 14766 broadcast/multicast datagrams dropped due to no socket This despite: wi0: flags=8843 mtu 1500 inet 1.234.56.78 netmask 0xff00 broadcast 1.255.255.255 udp4

Re: Receiving INADDR_BROADCAST packets

I think c) (perhaps combined with IP_RECVDSTADDR so that you know whether you got a unicast or broadcast) is the correct answer. I think binding UDP sockets to tell what interface/address was the destination is a historical artifact. Bill ___ [EMAIL P

Re: CFR: bridge locking

Maxim Konovalov wrote: [ CC: trimmed ] On Wed, 20 Aug 2003, 14:52-0300, Daniel C. Sobral wrote: [...] If you get bridge to send/receive packets to/from vlan interfaces attached to them, I'll be forever grateful. I've been trying to configure a setup where a firewall is connected to redundant swi

Re: [IPsec] ipcomp in tunnel mode still broken?

Hi, what is the config you are using to test this ? IPSEC ? FAST_IPSEC ? type of keying ? ---Mike On Thu, 21 Aug 2003 18:58:20 +0300, in sentex.lists.freebsd.net you wrote: >Hi there! > >It seems that ipcomp in the tunnel mode is still broken in at >least 4.x (I cannot test it with two

Re: Receiving INADDR_BROADCAST packets

On Fri, Aug 22, 2003 at 06:18:57AM -0700, Bill Fenner wrote: > I think c) (perhaps combined with IP_RECVDSTADDR so that you know > whether you got a unicast or broadcast) is the correct answer. > I think binding UDP sockets to tell what interface/address was > the destination is a historical artifa

How can I subnetting my network ?

Hi, all I want to build a network as shown below. All devices is in my responsibity except the upsteam router. My question is If I will assign public IP address to all interfaces, is it neccessary that I must inform the upstream router's administrator to add my subnet in routing

Re: How can I subnetting my network ?

>I want to build a network as shown below. > All devices is in my responsibity except the > upsteam router. My question is > >If I will assign public IP address to all >interfaces, is it neccessary that I must >inform the upstream router's administrator >to add my subnet in