On Sun, Dec 19, 2004 at 10:55:18PM +0100, Heinz Knocke wrote:
>
> By the way - do you know if sk(4) driver supports device polling
> (man 4 polling)? I know there were some plans
> to make it work, but I couldn't found any up2date information.
>
polling(4) isn't supported yet. I'm not aware of
On Sun, 19 Dec 2004, Heinz Knocke wrote:
> > Index: sys/pci/if_sk.c
> > (...)
>
> I tried this one and seems to work corectly :) Jumbograms were used, data
> stream was smooth,
> I haven't seen any error messages in system log.
> In rough tests I had a little bit better speeds than with this one:
- Original Message -
From: "Bjoern A. Zeeb" <[EMAIL PROTECTED]>
To: "Heinz Knocke" <[EMAIL PROTECTED]>
Cc: <[EMAIL PROTECTED]>
Sent: Thursday, December 16, 2004 2:45 PM
Subject: Re: Marvell 88E8001 on sk0 and RELENG_5_3 - big problems
> would y
On Tue, Dec 14, 2004 at 11:00:40PM +0100, Heinz Knocke wrote:
> b) according to the vendor's info, NIC should be able to do jumboframes.
> (http://www.marvell.com/products/pcconn/yukon/Yukon_88E8001_10_073103_final.pdf)
>
> ifconfig mtu 9000 works, but packets seems to come truncated (in both
>
On Tue, 14 Dec 2004, Heinz Knocke wrote:
Hi,
[sk(4) problems]
> Honestly said I don't know how to track it further, because
> the link layer (hardware or the driver) seems just to clip
> frames. If there's not enought info for the solution please
> tell me what tests can I do - I'll do it ASAP.
Hi!
Marvell's chip is not in supported nics section of 5_3 release notes, but in
man sk is , so I decided to write.
I've got some boxes with Marvell Gigabit NICs on-board (Gigabyte and ASUS).
Sadly, I can't be happy with it and freebsd 5.3 because of the following two
problems:
a) sk0 driver
