Hi all,
I have a Toshiba 2100CDS laptop with an OHCI USB controller
that gives a kue0: failed to load code segment error message
Rather than clutter the list, the conf file and the dmesg boot
file is available at
ftp.eas.slu.edu:/pub/incoming/[usbdmesg, usbbootmsg, usbltaconf]
The usbbootmsg is f
> Subject: Re: USB D-Link DSB-650 kue0: failed to load code
> To: [EMAIL PROTECTED] (Eric J. Haug)
> Date: Mon, 17 Jan 2000 15:48:42 -0500 (EST)
> X-Loop: FreeBSD.ORG
>
> >
> > I have a Toshiba 2100CDS laptop with an OHCI USB controller
> > that gives a
Hi All,
I recently purchased a Cyclades Cyclom-Yo4p serial adapter
upon booting i noted:
Mar 5 09:15:47 gumbo /kernel: cy0: port 0xf4
80-0xf4ff mem 0xffbe8000-0xffbebfff,0xffbee800-0xffbee87f irq 17 at device 15.0
on pci0
Mar 5 09:15:47 gumbo /kernel: pci_map_int: can't allocate interrupt
Mar
Hi All,
This laptop has a couple of problems with FreeBSD-CURRENT
of about 1999/12/22 12:00 UTC.
The system hangs with the disk drive light on.
The output of boot -vc captured from the serial port follows.
current of about 1999/12/11 works in PIO mode.
The machine has a built-in modem that appear
Sigh,
In my attempt to make a cdrom to install 5.0-CURRENT-2818
I stumbled across a problem with the fixit floppy.
The /dev/MAKEDEV acd0 created 209 entries. The fixit floppy
only starts out with some 382. So the fixit floppy fails to be
properly populated with executables.
Tar does not deal
