Are there any plans to support the emu10k1 chip (SoundBlaster Live! and
SB512) under FreeBSD?
I would love to help out, but I don't know where to start, and I have no
kernel programming experience. There are reference drivers available for
linux via http://opensource.creative.com or http://www.a
On Tue, 14 Mar 2000, Soren Schmidt wrote:
> It worked until the latest newbus changes, I'm looking at it, but havn't
> found anything obvious yet.
> But seriously you want to get another ATA interface, the CMD640 is
> _broken_ and no software can help that, you are playing russian
> roulette wi
Are there any plans to support the buggy CMD640 interface in the future
now that 4.0-RELEASE has come and gone? I have a box that is running 3.4
happily, and it has this interface. I really would like the chance to use
some of the 4.0 features, but I can not while support for this interface
lack
I had this problem last night with current.freebsd.org. I simply switched
to releng3.freebsd.org. I thought it was the same machine, but the IP
address was one bit higher. Aliased?
Good luck,
Tom Veldhouse
[EMAIL PROTECTED]
On Tue, 29 Feb 2000, Poul-Henning Kamp wrote:
> In message <[EMAIL
I have to wonder why? This was a common interface to
say the least.
Tom Veldhouse
[EMAIL PROTECTED]
On Tue, 15 Feb 2000, Brooks Davis wrote:
> On Tue, Feb 15, 2000 at 10:10:29AM -0600, Thomas Veldhouse wrote:
> > No overclocked bus. I do have the Pentium 166MMX overdrive processor on
> &
No overclocked bus. I do have the Pentium 166MMX overdrive processor on
the board though. It used to have a 100MHz Pentium in it. However, if
this is causing ATA some problem, it probably shouldn't. Like I said, the
old drivers in 3.4-STABLE have no problem with it and either does Linux.
Windo
I had a problem with Current (cvsup afternoon of 01-16-2000) locking up
solid. My machine did not respond to a ping from my STABLE box. I
finally pushed the reset button (ATX case) and it unfreezed the box. I
had a similar lockup about 1/2 hour later. Again, pressing the reset
button unfroze t
Something else I would like to see someday [assuming I haven't missed it
and it already exists], is TOS optimizations in much the same way that
Linux's ipchains utility can optimize protocols such as nntp, telnet, etc.
Since the thread is entitled ipfw optimizations - I thought I would add my
t
I wouldn't think so. However, the problem disappears when the PNP OS
setting is set to OFF on another box - and it reappears when I turn it
back on. When Linux boots - it says something to the extent that the card
has not been initialized by the BIOS - and then it does it - this is when
the driv
Why can't the driver enable the card instead. I can not shut the PNP OS
settings off on my mobo because of a Compaq "hack". Because of that my
Asante 10 does not start up - it does get detected though. Under Linux,
it detects that the card has not been enabled by the BIOS and then it does
it fo
On Fri, 17 Dec 1999, Soren Schmidt wrote:
>
> Hmm, the WDC WD200BA disk does UDMA66 doesn't it ??
> The VIA 82C686 has support for this, but its very "generous" in setting
> it. Form the above I'd guess you dont have a 80lead cable on those
> disks ?? What does the BIOS say about the disk mode
The only point I would like to argue is that this is not a comparison of
Apples to Apples.
Linux is just a kernel. There are Linux only utilities however
(i.e. util-linux). Each of the BSDs that you mentioned are full operating
systems. The closest comparison you can get is to compare a Linux
Tom Veldhouse
[EMAIL PROTECTED]
On Wed, 15 Dec 1999, Warner Losh wrote:
> In message <[EMAIL PROTECTED]> Thomas Veldhouse
>writes:
> : Does the newpcm system support the Sound Blaster 128 PCI card (ESS1371
> : chipset)? I am aware of a pcm dirver for it in STABLE, but
Does the newpcm system support the Sound Blaster 128 PCI card (ESS1371
chipset)? I am aware of a pcm dirver for it in STABLE, but I have not
tried it.
Tom Veldhouse
[EMAIL PROTECTED]
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
There a more Linux distros with grahical installs. Correl 1.0 - based
upon debian. Also, I believe that SUSE 6.3 has one also.
Tom Veldhouse
[EMAIL PROTECTED]
On Tue, 14 Dec 1999, Don 'Duck' Harper wrote:
> Sometime Tomorrow, Daniel C. Sobral said something like this:
> :-)But the fact is tha
Hello,
I have noticed over time that many people are test driving the new
ATA
Drivers. I attempted to do it a while back but I couldn't boot because of
the device name changes. I did not know what the new device names were.
Anyway - is there a simple HOWTO for using these drivers - and
Hello,
I just did the unthinkable and purchased a Compaq 5868 :-) I was
using an older (~10-30-99) snapshot of stable. That snaptshot worked fine
on my older PII-333.
The problem I am having is that the de0 interface will not come
up. I have manually tried to bring it up with
17 matches
Mail list logo
