AGAIN: lge0: MII without any PHY!

ert S. -- Robert Suetterlin ([EMAIL PROTECTED]) phone: (+49)89 / 3-3546 fax: (+49)89 / 3-3950 To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-current" in the body of the message

X11 unstable under CURRENT and STABLE.

4.7-RC i386 [ELF] 4.7-RC as of September 19th. X crashed after killing acroread with CTRL-C. (Un)fortunately I could not repeat this behaviour so far. Sincerely, Robert S. -- Robert Suetterlin ([EMAIL PROTECTED]) phone: (+49)89 / 3-3546 fax: (+49)89 / 3-3950 To Unsubscribe

problems with drivers lge and miibus on D-Link DGE 500SX

would be xmphy, which is correctly autoprobed under -STABLE. Do I have to configure something under CURRENT so that my miibus physicals are detected? My imphy on the fxp (EEPRO100) is detected ok. Regards, Robert S. -- Robert Suetterlin ([EMAIL PROTECTED]) phone: (+49)89 / 3-3546

stage 2 build of contrib/file breaks upgrade from 4.7PRE to CURRENT.

n conflict with defines in old include files also sucked in by ``usr.bin/file''. I do not see how I can get around this problem. Why is the build for ``usr.bin/file'' using old system include files at all? Regards, Robert S. -- Robert Suetterlin ([EMAIL PROTECTED]) phone: (+

more info: Q: Problems with device hints?

alled and I could not find any device hints concerning an isa digi card, and no hints for adresses 0x378 or 0x061. I checked /boot/kernel.conf, /boot/device.hints, and the CONFIG file I used to compile the kernel. Regards, Robert S. -- Robert Suetterlin ([EMAIL PROTECTED]) phone: (+49)89 / 3

Q: Problems with device hints?

: can't assign resources (port) unknown: can't assign resources (irq) Could anyone point me to a place where I can learn how to get rid of these messages, as I guess they are due to some wrong configuration of my system. Regards, Robert S. -- Robert Suetterlin ([EMAIL PROTECTED

digi_Xem: Failed to autoload module: No filesystem

after bootup there is no problem autoloading the digi_Xem module. Regards, Robert S. -- Robert Suetterlin ([EMAIL PROTECTED]) phone: (+49)89 / 3-3546 fax: (+49)89 / 3-3950 To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-current" in the body of the message

problems with drivers lge and miibus on D-Link DGE 500SX

over 100MBit Ethernet. Regards, Robert S. -- Robert Suetterlin ([EMAIL PROTECTED]) phone: (+49)89 / 3-3546 fax: (+49)89 / 3-3950 To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-current" in the body of the message