Hi Sam,
I'll address your comments and also Gene's. Back in 2005 when I started the
ELS project I was looking at using a TI DSP for the core processor and it had
hardware quadrature support but the infrastructure to write software and
program it put it out of reach for most of the people on the
On 8/28/24 06:58, Viesturs Lācis wrote:
Hello!
I have lately been posting questions that arise as I am doing
retrofits of two Biesse cnc machines. Mesa card setup is identical -
5i24 boards accompanied with 7i48 for encoder reading and analog
voltage for Yaskawa servodrives (analog signal only f
raw i/o with linuxcnc will do almost everything that the external hardware
will do.. You are just limited by how fast.
so.. Lets say you have a 4ns base thread. That means the base thread
runs at 25khz.. (I have a few i5 machines that seem to do a really good
2ns thread)
Any way..
Le
On Wed, 28 Aug 2024, Viesturs L?cis wrote:
Date: Wed, 28 Aug 2024 13:56:09 +0300
From: "[UTF-8] Viesturs L?cis"
Reply-To: "Enhanced Machine Controller (EMC)"
To: "Enhanced Machine Controller (EMC)"
Subject: [Emc-users] Encoder inputs on 7i48 not working
Hello!
I have lately been posting
Hello!
I have lately been posting questions that arise as I am doing
retrofits of two Biesse cnc machines. Mesa card setup is identical -
5i24 boards accompanied with 7i48 for encoder reading and analog
voltage for Yaskawa servodrives (analog signal only for those that are
working, encoder reading
