[Elecraft] KPA100 standoffs

2007-01-01 Thread Bob 'bz' Zinn
Message: 27 Date: Sun, 31 Dec 2006 23:54:36 -0500 From: "Dave & Jeanne Robertson" <[EMAIL PROTECTED]> Subject: [Elecraft] KPA100 Standoffs between heat sink and board ... Ben, I just finished building my KPA100 and it is quite happy in the K2 at this time. I agree with your observation of the

[Elecraft] something is bugging me, K2 keying problem.

2007-01-04 Thread Bob &#x27;bz&#x27; Zinn
I hooked up an old bug to my keyer paddle. I used a couple of junkbox diodes and made sure that they matched as far as forward voltage. [.542 and .541 on my radio shack meters diode check mode.] I have also tried a 0.01 cap across the bug. Even in test mode (so it isn't RF in the shack that

RE: [Elecraft] Installing KSB2 and Rework eliminator

2007-01-04 Thread Bob &#x27;bz&#x27; Zinn
Phil, I just finished building k2/100 #5884 with KDSP2, KNB, KAT100-1, K60XV, K160RX and KSB2 adapter. As also a former electronic tech (FCC 1st phone, 2nd telegraph w/radar endorsement, TEA CET in Audio, radio/television & industrial electronics, a couple of year board repair of mini computers,

[Elecraft] Things I would do differently when I next build a K2

2007-01-12 Thread Bob &#x27;bz&#x27; Zinn
Have recently put together K2/100 #5884. I hope this is not too presumptive of me, but I have a few suggestions. These are things I would do in the future, that I did NOT do this time: 1) I would buy at least 4 different colors of 'nail polish' to use in color coding those little brown monolyt

re [Elecraft] Things I would do differently when I next build a K2

2007-01-13 Thread Bob &#x27;bz&#x27; Zinn
My thanks to all who have commented on my rather lengthy post. I responded privately to many of them. Date: Fri, 12 Jan 2007 11:03:22 -0800 (PST) From: "Fred (FL)" <[EMAIL PROTECTED]> Subject: [Elecraft] Things I would do differently when I next build a K2 Some good ideas - If I did it again

[Elecraft] Re: Elecraft Digest, Vol 32, Issue 27

2006-12-24 Thread N5BZ, Bob &#x27;BZ&#x27; Zinn
I had a similar problem, yesterday. I just built K2/100 #5884 and everything was ok until I started alignment of the KPA100. After a few minutes of getting normal output at 5 watts, I suddenly started getting 'High Current', intermittently on 7 MHz, then on every band. Dropped back to signal

[Elecraft] RE: armed forces day test

2007-05-12 Thread N5BZ, Bob &#x27;BZ&#x27; Zinn
Very disappointed to see NO cw operations on Armed Forces Day. I remember the fun of working NSS, AIR and WAR on cw and getting their QSL card. Had hoped to hear them pounding brass again. It was also fun to copy the Sec. of Def.'s Broadcast on CW and get a certificate for that. I was plannin