On Sat, Jun 03, 2017 at 09:00:04PM -0400, Haines Brown wrote:
> Ged, thank you for the reply. But it leaves questions in my mind.
>
> On Sat, Jun 03, 2017 at 02:04:05PM +0100, G.W. Haywood wrote:
>
> > >Installation of Jessie 1.0.1 AMD64 went well.
> >
> > Considering what you write below, I'm n
On Sun, Jun 04, 2017 at 09:54:38AM +0100, KatolaZ wrote:
> I don't know exactly what your custom "installation routine" entails,
> but since there have been a few dozen thousands successful Devuan
> installations in the last few months, and nobody has reported anything
> even remotely similar to th
Hello Haines,
On Sun, 4 Jun 2017, Haines Brown wrote:
I have an installation routine I've used since Lenny and perhaps
even Etch. I stuck to it, and generally accepts defaults.
A list of exactly what you started with and exactly what you did,
step-by-step, would be more useful to the problem-
On Sun, Jun 04, 2017 at 02:54:22PM +0100, G.W. Haywood wrote:
> Hello Haines,
>
> On Sun, 4 Jun 2017, Haines Brown wrote:
>
> >I have an installation routine I've used since Lenny and perhaps
> >even Etch. I stuck to it, and generally accepts defaults.
>
> A list of exactly what you started with
On Sun, Jun 04, 2017 at 10:42:23AM -0400, Haines Brown wrote:
> Another anomaly is what when I boot the old devuan, the boot goes to
> recovery mode despite what is selected in the GRUB menu. A control-D
> continues the boot normally. It showed up only fairly recently. But
> since I seldom reboot
Did a re-install from DVD ISO on key.
I first commented all commands to boot Devuan partitions from my Debian
fstab. In BIOS I changed disk priority so that the Debian disk would
boot.
I booted the Devuan installer and choose expert install.
I select all defaults unless otherwise noted.
Detect
Interim report.
Without USB back drive installed, I installed the Jessie DVD ISO from
key. Do simply installation routine.
When it came to partitioning, I accepted a single partition on entire
target disk. Oddly my backup USB drive still reported as a possible
target even though it is disconnecte
I just ran into a similar issue trying to use reportbug on a computer I
installed Devuan 1.0 Stable a week ago today using the Netinstall ISO.
Here is what happened when running reportbug for the first time:
$ reportbug flashplugin-nonfree
Warning: no reportbug configuration found. Proceeding in
