7;s IP address
"10.10.0.175:9000" with the UDP sink and UDP source. However, when using the
host's public static IP "166.149.xxx.xxx:9000", Gnuradio throws the
following error:
/Traceback (most recent call last):
File "/home/matias/Documents/top_block.py", line 1
". We later found that lowering the low cutoff frequency
to 1MHz and the high cutoff frequency to 8MHz (<= sampling_freq / 2), the
program checks pass but the GUI scope will not show any output. Are we using
this correctly? Is there perhaps a better way to get rid of the aliasing?
T
Hello List,
i'd like to enter in this world but i have a lot of doubts, mainly in hardware
parts. I have one jerrold 5500 general instruments baseband downconverter. I
would like to know if i can use it with gnuradio. I want to start with
something that i have to get experienced, so i will buy
Hi,
i'm trying to receive the dedicated control channel SACCH (GSM)
between MS and BTS (MS --> BTS). But to do this task i need also
listen the control channel between the BTS and MS. My question is if i
can receive this two signals (diferent spectrum) at the same time with
my board (USRP + DBSRX)
2009/6/11 Matt Ettus :
> Matias Torres Risso wrote:
>>
>> Hi,
>>
>> i'm trying to receive the dedicated control channel SACCH (GSM)
>> between MS and BTS (MS --> BTS). But to do this task i need also
>> listen the control channel between the BTS and
Hi,
I have a USRP with 2 DBSRX daughterboard so i can capture the downlink
signal (GSM) and the uplink (i'm not sure of this). Someone here knows if
the RACH channel is transmitted in the UPLINK part of the broadcast channel
(BCH), this is 45 mhz below the downlink channel (GSM900), corresponding
